New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

used my la jack

Posts

used my la jack

#1

used my la jack

Jerry Gibbs

Used my new LV LAJ to trim the edges of hatch boards on the boat. The trimmed portions are a combo of plywood and teak, including end grain. Worked great, but then I am a newbie. Maybe is was just the sharp blade. Used the low angle blade (37 deg total) for all edges and it worked fine. Much better than a belt sander with 60 grit. Jerry

Re: used my la jack

#2

Indeed.....

Bill Tindall

it is a pleasant discovery to find that planer shavings, or even scraper shavings, removes wood at a greater rate than sand paper........providing the blade is sharp.

Re: used my la jack

#3

I like the precision, too

Bill Houghton, Sebastopol, CA

Yesterday, I spent a little while shaving down the jamb extensions I'd had to install on the remodel windows going into the current project: Stanley No. 60-1/2 block plane and a Wards Master No. 4 bench plane. Naturally, the sheetrock varied from top to bottom of the windows, and unequally on the two sides. I can't imagine a power tool that could have brought those down to the level of the sheetrock with the same precision and no terror.

Re: used my la jack

#4

Moses Yoder

Re: used my la jack

Moses Yoder

What did you use to sharpen the iron? Just curios.

Re: used my la jack

#5

Re: used my la jack

Jerry Gibbs

The iron is A2, not start anything. This was the plane's first significant use and I used the iron straight from Lee Valley. Jerry

Re: used my la jack

#6

warning....learning curve lies ahead

Bill Tindall

One's success with a hand plane will depend on one's ability to sharpen it. You have my sympathy trying to choose among the bewildering array of choices. There is nothing to be ashamed about starting with "training wheels" (AKA sharpening jig). I think it is most easily used on sand paper fastened to a flat surface like Corian, glass, granite. Pieces of scrap granite back splash can be had for free from our local fabricators. Start simple and cheap. Use what you learn to progress. If you use a plane a lot, you will sharpen a lot and the training wheel will become unnecessary.

Re: used my la jack

#7

Moses Yoder

Re: training wheels

Moses Yoder

Although I design woodwork projects (cabinets) for a living, I actually only build about 2-4 projects in a year in my hobby shop. That means I only sharpen irons during those twice or four times in a year proects. I like my training wheels and kind of doubt I will ever be giving them up. Especially now that I am on lithium, which usually has the side effect of making you shaky. I am on medication to help keep my hands steady but they are still very shaky.

I agree with starting sharpening with sandpaper. It's cheap and effective. A step up would be water stones, which are easy to keep flat and give you a very nice edge. Next up is either ceramic stones or diamond on a substrate, which is a debate for another thread, where guns are likely to be fully loaded and drawn.

Re: used my la jack

#8

Re: warning....learning curve lies ahead

Alex Grigoriev

Microfinish M3 sandpaper sold by Lee Valley worked well for me. 15 micron SiC, 3 micron SiC, 0.5u CrO (green). 3u and 0.5u stick to slightly oily glass without any adhesive. Make sure to use a roller to get rid of air bubbles.