New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

using taper or reamer

Posts

using taper or reamer

#1

using taper or reamer

StephanieSuesanSmith

I am building a shaving horse and needed a taper or reamer to set the taper on the leg holes. I could not find one that was not extremely expensive, so built one out of osage orange (bois d'arc), the hardest wood on my property. It set the taper properly in the piece of oak I am using for the seat, but getting it back out of the hole was rather difficult. There has to be some trick to doing this. Would someone enlighten me, or point to directions? Thank you.

The picture was taken with a cellphone, the good pictures are not developed yet. Sorry for the picture quality.


Re: using taper or reamer

#2

Re: using taper or reamer

Larry Barrett

Your tapered reamer looks good. I have used one many times and find I need to pull it out of the hole frequently to clear shavings; by doing so frequently I have not had the same problem you seem to have had, so that may help. Below are a couple of links for similar reamers.

http://www.greenwoodworking.com/SawSteelTaperedReamerPlans

http://www.handtoolwoodworking.com/tools.html

Re: using taper or reamer

#3

Re: using taper or reamer

Greg B�tit

Keep turning the reamer as you are removing it from the hole. The same is good for the legs when you want to remove them after a dry fit. I wouldn't think you actually needed a tapered joint for the shaving horse, but that's just me.

Re: using taper or reamer

#5

Re: using taper or reamer

StephanieSuesanSmith

This is actually the plan I am using, and I got the plan for the reamer here, too, but somehow it didn't work as smoothly as I envisioned. Probably because this is iron oak that was from a storm three weeks ago and isn't really the green wood this was intended for.

Re: using taper or reamer

#6

Re: using taper or reamer

TD

I works fine in dry wood. I made one of those by hand in much the same circumstance as you are in.

My tips would be that assuming the taper is correct, and you relieved it, then: Sharp, correct projection, and the teeth were left in place. Shape is obvious; projection is easily adjusted by shiming from the base of the slot; sharp saw teeth help, but aren't essential. Also let the tool do the cutting, mine was more effective than the 100 dollar machined reamers, very surprising. So it isn't necesarry to jam it in really hard, cut it in, so it will not get stuck in the first place. The steel does the cutting the wood is just a guide.

Re: using taper or reamer

#7

Re: using taper or reamer

Greg B�tit

The tapered tenon is not necessary, on that shaving horse or any other. A wedged straight through tenon works fine. Drill the holes, turn your tenon to fit, wedge and glue. Someone who wants to get started using a shaving horse need not be slowed down by the more complicated tapered tenon joint.