New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Found wood (somewhat OT)

Posts

Found wood (somewhat OT)

#1

Found wood (somewhat OT)

Paul M.

I ride my bike on lots of remote trails around San Diego. It's been pretty bleak the last few years in one particular area called Cuyamaca since ALL of the trees in this forest were killed in a massive fire back in 2003. There's lots of standing burned deadwood, and every big windstorm brings down another few hundred dead trees. Usually these are burned and checked hulks useful for nothing but firewood or mulch.

I found the log below while climbing a very remote fire road. The forest service cut the log into movable rounds, and pushed it off the fire road. This road is blocked from vehicle traffic by metal gates on all ends of the road, so the only way there is to either work for the forest service to get a vehicle in, or hike/bike to get there.

I had to stop and drool over this log for a while. The wheel diameter on my bike is 29" and this particular round was about 3 feet long. I think there must be well over 50 guitar tops sitting there inside that one chunk of free wood. It's either pine or douglas fir, so it's not a valuable wood. But seeing this huge round of wood with absolutely no stress or drying checks was unbelieveable. The growth rings were reasonably tight on this log too (about 10 per inch).

I mentally started thinking about what I needed to buck this cubic yard of wood into billets and then drag them down the mountain to the nearest accessible location about 2 miles away. Some huge saw would be needed for quartering, and a large froe for reducing the quarters down to smaller radial billets. That seems daunting for what can only be called 2nd grade lumber. But dang it sure looks pretty and it's absolutely free.

Has anybody recovered wood from a remote and inaccessable location? Please share the story on how this was done. Also could lumber this clean come from deadwood that was standing vertical for 8 years before it recently fell? It seems to hard to believe that there are no checks after that period of time.


img

Re: Found wood (somewhat OT)

#2

Re: Found wood (somewhat OT)

Bruce, a MN Galoot

In a former life I used to work closely with the Forest Service. I know they would have hauled some of that out for me, just for the asking. It sure doesn't hurt to ask...

Re: Found wood (somewhat OT)

#3

Re: Found wood (somewhat OT)

TomD

Normally I proceed either by wedge or by chainsaw. There is no way I could pop that log as a hard wood, but maybe a wedge would open up a really straight piece of softwood that size.

If the forest service does not take a leave only footprints take only photos approach they might help.

My other observation has been that the sweat to reward ratio of found wood is often not worth it. Free makes me want it, but I am constantly surprised at how much better a lot of commercial wood is. How hi-graded it is. Of course one should do what one can to tap into free wood, that is a great idea, just be careful about grade, if you wouldn't buy it maybe you shouldn't take it free, it isn't really free anyway. Turning is great that way because length isn't a problem for the most part and areas like crotches reliably release treasure. That beech I got last year was great, partly because planes are small, but even with all the rot there was a lot of usable wood, I left a lot of it.

Re: Found wood (somewhat OT)

#4

Re: Found wood (somewhat OT)

Todd Nebel

You're right Tom. I once offered to take down a damaged tree from a storm for a neighbor because it was covered in burls. Free wood for just the effort :). Then when I cut into it I found it was rotted and hollow :(. But a promise was a promise so I took it to the dump on my time and gas. I never looked for free wood again.

Re: Found wood (somewhat OT)

#5

Re: Found wood (somewhat OT)

Pam Niedermayer - Austin, TX

My idea of free wood is what the local tree cutter drops off on his way home. :)

Pam

Re: Found wood (somewhat OT)

#6

Re: Found wood (somewhat OT)

Paul M.

Hi Tom,

I agree on the reward ratio. I'm pretty sure that I would be disappointed in the end material after all that work to heft the billets off the mountain.

A couple of responses requested getting help from the forest service. That's pretty much a non-starter here in California (pioneers in the art of government shutdowns). This particular state park was "closed" for a while last year. But "closed" just means no forest service, and everybody who is interested still visits. I'm surprised that the forest service came out to this road once already. The odds of finding them in this area again are probably zero.

I will take Tom's guidance to heart, and let this wood slowly decay. I just cannot wrap my head around the logistics of getting a long bar chainsaw up the mountain to do the initial bucking. Trying to wedge apart 3' wide x 3' long lumber that has been dry for 8 years by hand is also too daunting.

Re: Found wood (somewhat OT)

#7

Probably wise thinking...

Doug Trembath

As a woodturner, I've bucked up a lot of wood, under some pretty strange circumstances, and I can understand your longing to work this wood rather than seeing it crumble.

However, your thought of getting a big chainsaw up the mountain pales in reference to getting the wood down the mountain, on a bicycle. You must be SOME rider! :)

I've pulled large sections up and down hills with a variety of mechanisms, including just pulling on a rope, but your task is infinitely more daunting...

Too bad, though... Looks like pretty wood!

Doug Trembath