Re: I say once. Say again...
TomD
I have the LN Jack, and the LV jointer. I think you will enjoy a low angle plane.
I love that thing about a Bulgarian Police shoe, though I think my LV jointer is actually quite handsome. I think LV made a kinda error, when they figured their slot was on the ugly side of LN. Turned out they turn out a premium plane performance wise, and it is hard to believe the ugly bit is saving anyone any money. Like a discount grocery store where they take a regular store and spend a million in reno making it look like a place that sells cheap food.
Blade wise you have two decisions:
- Whether to buy two blades. I think this is a waste of money, you should be shooting for specialized planes so you can just pick them up and go. In the real world, I would probably opt to set the one plane for a good compromise setting like 40 degrees. That said, I don't see how it will hurt to do what you are planing, and it could be rather fun as an experiment. Depends on whether you are playing at being a tool experimenter, or are a get 'er dun, kinda user. These days a lot of us are into the tool games stuff since that is one of the strong messages of magazines etc... Tools are something you test, vs use. For the kind of person who just wants to get the sideboard done, you are better off not complicating maters.
- O1 or A2. I like O1 for a variety of reasons. Trying to see things from you perspective, the argument would be: Less discouraging for a beginner to sharpen. The plane you are choosing is relatively easy to do a sharpening cycle on, compared to an old Stanley or something. Most of the other tools currently available will not be available in A2 or other super steels. It is best in my book to have one type of steel on the go so you are doing the same thing with the same gear.
The contrary position favouring A2 would be if:
- Most of your woodworking is maple or harder woods
- You are going to raise heaven and earth to get only super steels in the rest of your tools
- You are going to adopt from the outset production methods of sharpening
- You aren't interested in traditional tools, and the woodworking they produce, so you won't later want C&W planes, hollows and rounds, antique tools for restoration, Japanese tools, etc... Speaking broad brush.