New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

chair repair

Posts

chair repair

#1

chair repair

Bruce, a MN Galoot

I posted this on the main board, but I just realized (I'm on night shift, brain doesn't work so well) that there are probably more fixers on this side.

I'm fixing up a basket case chair for a friend. Every joint on the thing has to be re-done. The seat rails are doweled into the legs, and a couple are broke off, so since there is enough wood I'm routing out the dowels and replacing them with floating tenons. That's pretty straightforward.

The question I have is about the stretchers. They are doweled as well, but there's not enough wood to drill them out and start from scratch. Besides, the holes on the legs have been glue and re-glued, so they need to be scraped out, and maybe drilled before I get to useful, clean wood.

I plan to wrap the dowel ends on the stretchers with veneer and let the glue set up before final fitting. Is paper a valid substitute for wood veneer to wrap the dowel ends?

Or is there another technique I should use?

Thanks

Re: chair repair

#2

Re: chair repair

Pam Niedermayer - Austin, TX

You might try some hot water or alcohol in those gluey holes, should save some scraping time.

If your friend expects to actually sit on this chair, might be better to replace the stretchers. Dowel stock is not that strong, although in very short lengths it might be OK, judgement call. At any rate, a loose tenon doesn't sound all that good in a chair.

Pam

Re: chair repair

#3

Jack Guzman from Maine

Re: chair repair

Jack Guzman from Maine

Bruce,what I do is set a plane up to get the proper thickness shaving and wrap the dowel with the shaving. Personally I would not use paper.Although it may help by absorbing glue and acting as a gap filler,with moisture paper reverts to mush.---Jack

Re: chair repair

#4

Stephen Shepherd

Re: chair repair

Stephen Shepherd

Bruce,

I use fine linen cloth and rip it into strips and wrap them around the loose tenon and apply hide glue and clamp them together.

Veneer swells and can crack, I do use veneer on square tenon repair, and as Jack said paper turns to mush, especially modern paper, old rag paper stays together better.

Stephen

Re: chair repair

#5

Re: chair repair

Patrick Gibbons

I've used Chair Doctor glue from Lee Valley. It causes the wood to swell up and then lock in place. It's generally very effective and quite easy to use.

Re: chair repair

#6

But is it reverseable/repairable?

Bob Hackett

Re: chair repair

#7

Re: chair repair

TomD

Paper might be a valid substitute for wood shavings if it was saturated with some epoxy. Otherwise i wouldn't trust it.I would think wood shavings might be easier to apply since they are pre-curved and pretty strong.

Another option to paper, shavings etc... is some real epoxy, like WEST 105. It will make a very solid joint. Fine Woodworking even did a video on using it in round tenon joined chairs. It can fill up to a 1/4" gap. The only issue is keeping the glue in the joint. If the gap is significant, you might have to add a little thickening, and there are special materials for that. One option is wood flour, but even real flour might work to thicken it up so it doesn't slump If over time the wood expands and contracts and eventually the rung comes out again, it can be reglued with epoxy again. The stuff will glue to itself.

Re: chair repair

#8

WOW, I actually agree with Stephen...

Scott Burr in Ben Lomond CA

Wadda ya know!?! This was how I was taught to do a fix like this as well.