New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

They are hand held

Posts

They are hand held

#1

They are hand held

Phil Joines

I'm fixing to make some metal spinning tools. Normally they are made from 1" round high carbon steel and hardened. I can't afford that and since I have a bunch of hot rolled I'm thinking of case hardening them. The "proper" way is to heat them for about an hour in a furnace after applying the compound. I don't have a furnace either and the one at the local tool and dye shop isn't long enough. So anyone ever done a quick and dirty job with an acetylene torch?

Re: They are hand held

#2

Spinning tools

Bob Hackett

Pics?

I ask because I have had good luck using things like pry bars and garden tools and doing things like brazing ball bearings on the end of the shank.

You also may want to look at scissors type tools that can be made from cold rolled and have roller type forming ends with bearings in them.More leverage,speed and power and less wear and tear on the operator.

Re: They are hand held

#3

David Barnett

True, but a tool rest/post isn't a bad idea

David Barnett

While one can case harden with a torch, it involves repeated heatings and case medium quenchings and yields spotty results. Your real problem would most likely be getting the tool shape right the first try as the case may be too shallow for subsequent modification. For spoons and combi-spoons you could use HSS, but you don't have that.

As Bob suggest, you can find all manner of tool steel for repurposing. Harbor Freight can be useful for this. The ball bearing on a stick trick is good. Be sure to flat one side of the bearing before brazing, though, and wear protection, eye and otherwise. Don't forget brass can be used to spin some metals, too. Also, the case won't hold for long with any forged cutter shapes. Best to affix a piece of tool steel to the cheaper handle steel.

Re: They are hand held

#4

Re: They are hand held

TomD

I would try a few different things first:

1) Just use the hot rolled, it might well be hard enough if you are spinning soft stuff

2) Heat it with the torch, and quench it in super quench that will medium harden your stock

3) Get some hard surfacing in stick or there is gas stuff also, and weld it on the end, and voila hard end

4) Use your oxy torch to braze on a ball bearing. If you try that, read up a bit first since there are avoidable risks heating bearings.