New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Knew Concepts Fretsaw - updated review

Posts

Re: Knew Concepts Fretsaw - updated review

#2

Re: Knew Concepts Fretsaw - updated review

TomD

That's cool. Another fancy tool!

I just put the blades in backwards and tweak them 45 degrees, never lost a lee valley blade. This allows me to use a pretty small saw with nice balance. For the tails, on drawers and such they can be cut with a power fret saw.

Re: Knew Concepts Fretsaw - updated review

#3

Re: Knew Concepts Fretsaw - updated review

Scott in Montana

Derek,

Thanks for another high quality review.

I do have a question. Is the handle size as annoyingly small as that of my old Olson saw? I currently wrap mine with hockey stick tape as suggested by Rob Cosman as to increase the diameter and therefore better fit my hand. But it just looks so ugly in my tool cabinet.

Scott in Montana

Re: Knew Concepts Fretsaw - updated review

#4

Re: Knew Concepts Fretsaw - updated review

Derek Cohen (in Perth, Australia)

Hi Scott

The handle size is about the same as the Olson.

I don't have a problem with this, and my hand is quite broad (I am told), measuring 100mm across. In fact, my jeweller's saw handle is slimmer.

Regards from Perth

Derek

Re: Knew Concepts Fretsaw - updated review

#5

Re: Knew Concepts Fretsaw - updated review

bugbear

I currently wrap mine with hockey stick tape as suggested by Rob Cosman as to increase the diameter and therefore better fit my hand. But it just looks so ugly in my tool cabinet.

Time to google Tsuka-maki (sometimes Tsukamaki)

BugBear

Re: Knew Concepts Fretsaw - updated review

#6

Re: Knew Concepts Fretsaw - updated review

bugbear

Cam tensioning, you say?

http://toolemera.com/pampdf/the_art_of_fretwork.pdf

P11, fig 4

Ain't nothun' new under the sun

(Except titanium fret saws!)

BugBear

Re: Knew Concepts Fretsaw - updated review

#7

Re: Knew Concepts Fretsaw - updated review

Derek Cohen (in Perth, Australia)

Ain't nothun' new under the sun

(Except titanium fret saws!)

Nuthin', BB, except a design that creates a rigid frame, a taut blade, and a managable tool .... as opposed to a springy, twisty, banana. :)

Nice find on the book, nevertheless! Your encyclopaedic recall never ceases to amaze me!

Regards from Perth

Derek

Re: Knew Concepts Fretsaw - updated review

#8

Re: Knew Concepts Fretsaw - updated review

bugbear

Nice find on the book, nevertheless! Your encyclopaedic recall never ceases to amaze me!

Does the fact that I own 3 of those fretsaws (14", 16" and 18") reduce the amazement?

BugBear (cheating on a memory test)

Re: Knew Concepts Fretsaw - updated review

#9

Or, if you're feeling less ambitious,

Bill Houghton, Sebastopol, CA

you can get a rubbery plastic compound in cans - dries to a texture very similar to the rubbery grips you find on some power tools. While each individual layer's pretty thin, I bet you could build it up to a fairly impressive thickness by repeated dipping/drying cycles.

Warning: if you get one of those cans, look around the shop for handles to cover. Once you open the can, it starts drying out, and a can full of hardened rubbery plastic has limited uses in the shop.