Another Shooting Board Question
Roninkokomo
When shooting multiple items as in a picture frame. How do you control for accurate length?
Knowledge You Can Build On — Est. 1998
Another Shooting Board Question
Roninkokomo
When shooting multiple items as in a picture frame. How do you control for accurate length?
Re: Another Shooting Board Question
Moses Yoder
When I am making a 4 sided frame it is important that the parts on each end are identical length. I normally just trim one piece and then hold it against the opposing piece so I can see how much needs to be trimmed off then trim and check several times until they are both identical length. I have never seen a shooting board with a length stop on it but perhaps there is such a thing. I suppose you could also clamp pieces together and shoot them both at the same time.
Re: Another Shooting Board Question
Derek Cohen (in Perth, Australia)
Hi Ron
I mark a thin line with a knife, and shoot to this.
When opposite ends are placed back-to-back fingertips can tell if they are the same length. But it is not a perfect system.
Michael Connor has an interesting shooting board, actually more of a donkeys ear, and he demonstrates two shooting opposing sides at the same time. I think that this is an excellent idea ...
Regards from Perth
Derek
Pretty much like Derek
Scott Burr in Ben Lomond CA
Mark out the length, cut saving the line, then shoot to the line.
Re: Another Shooting Board Question
roninkokomo
Thanks guys. I was pretty sure of the answer. I just wanted to make sure that I wasn't missin something.
I also figure that for most stuff a good shooting board is more useful than a Lion Miter Trimmer which I have.
Ron
Used together...
Scott Burr in Ben Lomond CA
You'll get really good results using the shoot board then the loin trimmer.
Re: I'm not having what he's having...
TomD
"loin trimmer"
Wow! You Cali boys are tough!
Re: I'm not having what he's having...
roninkokomo
Tom
I am with you. Can't spare any
Really??
roninkokomo
If the shoot board and well tuned plane does what it is supposed to do, do you really need both?
No...
Scott Burr in Ben Lomond CA
Probably not. But, The lion trimmer would correct any deviations easily.
Boy, I need to watch my spelling 
No trimming here
Bob Hackett
I`m to busy girding my loins to trim them.
Then again if I trimmed them they might be easier to gird.
I wonder if I can use diamond to trim them efficiently? Hmmm...perhaps someone will come along and offer an alternative approach.
NAH!Back to girding! 