New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

OT - condensation on sheet foam insulation

Posts

OT - condensation on sheet foam insulation

#1

OT - condensation on sheet foam insulation

Bill Houghton, Sebastopol, CA

We're preparing to insulate the cathedral ceiling of our shed conversion with 3" of polyiso sheet foam. Each rafter bay will be ventilated with a large soffit vent and continuous ridge vent.

Polyiso foam comes standard with aluminum foil on each face. Our son has heard from some roofers he's talked with that this construction detail creates problems with condensation on the upper face of the foam, running down to the lower edge where it drips off to start rotting the wall.

Is this in fact an issue? A local supply house can get me tarpaper-faced polyiso, but this doesn't serve as a vapor barrier (may not be an issue anyway; I will probably install a vapor barrier or use vapor barrier primer).

Re: OT - condensation on sheet foam insulation

#2

Re: OT - condensation on sheet foam insulation

TomD

I would spray it. I was at the home center the other day, and I was looking at the kits they sell. They are probably a lot cheaper where you are. Was, like 380 for 200 bft. I hear tiger foam is good. Comparatively the foam board was 16 dollars for 48 bft. My thought was to make my own SIBs. I could get the two pieces of ply for like 20-40, and two pieces of foam for 35. It would cut down on framing also. One can vac back several panels at the same time. I probably only need 5. If it turns out I need 4x10 footers, it would kinda make it too expensive/hassle. With solid construction venting isn't needed and mold is mitigated. In fact, while it could be expensive there is the option of getting blue ply for one layer. Some places actually sell foam in 4x8.