New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Raising a burr

Posts

Raising a burr

#1

karl jr

Raising a burr

karl jr

Hi all!

I usually hang out over on the round side, and I've got a hand tool question. Is there a quick and dirty way to raise a burr on a card scraper? Or must I go through the entire process of filing and then honing, and then raise a burr?

Re: Raising a burr

#2

Moses Yoder

Re: Raising a burr

Moses Yoder

I usually turn the burr 3 or 4 times between honing. I make about 3 or 4 passes with the scraper flat on a table then hold it upright in my hand and turn the burr at about 10-15 degrees. When it won't cut right anymore it needs to be honed again.

Re: Raising a burr

#3

karl jr

LOL

karl jr

LOL! "Turn the burr," says Moses. The joke's on me!

Seriously, thanks. I know now what I was doing wrong.

KTK

Re: Raising a burr

#4

For some work...

Bob Hackett

I find a scraper easier to use without a burr.Just file,hone and go to work.

When it stops cutting ribbons (and starts raising dust) I pull out my pocket diamond hone and refresh the edge.

Re: Raising a burr

#5

karl jr

Re: For some work...

karl jr

I've obviously got some learnin' to do. You and Moses both have given me something to think about while I'm working. Turning a burr is something that I wasn't really doing. I suppose my honing skills also nee some, er, honing.

At any rate the scraper has been working out all right, once I got it kind of figured out.

I've been using the scrapers on natural edge bowls, btw. They've saved me a lot of sanding, and I get a better surface to boot. Holding on to the sucker while scraping the inside of a bowl has been interesting, let me tell ya.

Thanks

17 bowls out the door, and 18 to go on friday

KTK

Re: Raising a burr

#6

Turning the burr

Bob Hackett

The first thing I had to understand was to use a light touch.I was thinking"I`m bending steel here,better put some grunt behind it".Not so,too much pressure curls the burr to the point where it has to be laid down at a steep angle to cut if it cuts at all.

A little dab of light oil on the burnisher and a light touch will do the trick.

I too use them to smooth the insides of natural edge bowls especially those 2 areas that fuzz up coming into and out of the end grain.They work some slick,don`t they. :)