New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Bees wax question

Posts

Bees wax question

#1

Bees wax question

Joe in a Cleveland suburb

I remember watching a Roy Underhill episode on line some time ago where he made a, I think it was called, dovetailed grease pot. In it he put some kind of mutton fat/grease or wax or something. When I re-watch the episode, he says it so fast that I am not sure what he is saying.

But I saw something about it recently and wondered about a hard chunk of bees wax I have. Using this wax, I sometimes scribble some wax lines on the bottom of a plane, or on a hand saw, screws, and/or similar uses.

I kinda remember reading here a while ago about melting wax and mixing in some kind of solvent to make a softer wax that would stay soft. Something like Crisco that you could put on your plane sole, screws, and so on.

Am I way off base in remembering this? Can you tell me the process of doing this?

Thanks!

Re: Bees wax question

#2

Turpentine?

Thomas Skaggs, Foothills of Mount Level

Was it possibly turpentine? I know that mixing turpentine with beeswax will make a soft wax finish.

Tom

Re: Bees wax question

#3

Ask Stephen Shepherd.

Dan Donaldson

Re: Bees wax question

#4

Re: Bees wax question

Frank D. in Montreal

Hi Joe,

I can't comment on what was already said on the subject, but I make my own paste wax, and any mineral-based solvent will do the trick. I prefer low-odour mineral spirit like Varsol or even better, Izosol. They smell less than paint thinner and are less toxic than paint thinner or turpentine. For some added glide and for a mixture that will stay on longer, add a bit of carnauba wax to the mix. You can get the consistency you like by simply adding more solvent to the wax flakes or pellets. I don't even heat the mixture: just add enough solvent to cover the wax, then stir three or four times during the first 24 hours. After that, add more solvent if you want a thinner consistency. The wax should fully dissolve at room temp within 3 days. I much prefer wax over tallow any time.

Re: Bees wax question

#5

Stephen Shepherd

Re: Bees wax question

Stephen Shepherd

I mix up half lard and half beeswax, warm the mixture taking care not to burn it; makes nice stuff for your grease box.

Stephen

Re: Bees wax question

#6

Re: Bees wax question - tallow ??

John Aniano in Central NJ

Joe,

Perhaps you were remembering an article in a recent issue of Popular Woodworking, detailing the use of mutton fat or tallow on the bottom of plane soles? From the PW site : "Roy Underhill shares Tallow Tales & Black Planes of Britain in Arts & Mysteries" in the August 2010 issue.

Is that it?

John

Re: Bees wax question

#7

Re: Bees wax question

Jerry Nicholson

I have had better luck dissolving beeswax with mineral spirits than with turpentine. Smells better too!

Jerry