New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

more cutting board questions

Posts

more cutting board questions

#1

more cutting board questions

Edward in Vancouver

Have all of my cutting boards glued up, and have two of them surfaced now. "Sandwiching' the strips beween two laminated faced mdf scraps (sink cut-outs) during glue up sure helped in getting them flat, and flooding the surface with mineral oil (heck I am going to treat them with mineral oil anyway...) made fairly easy work with my bu jack--no toothing blade, haven't had time to get one yet.

My question now is, can I wrap the board with a hardwood edge? I have some walnut and purple heart scraps and thought a hardwood edge would look good. However, every picture I see of a end-grain block does not have edging, probably due to wood movement. Would it be wise to put hardwood edging on a end-grain block?

Re: more cutting board questions

#2

Re: more cutting board questions

Bill Houghton, Sebastopol, CA

I just don't see how that would work, unless your boards are going to live somewhere that the humidity is absolutely unchanging all year long - say, in a climate controlled clean room.

Re: more cutting board questions

#3

Re: more cutting board questions

Edward in Vancouver

Yeah, that would make sense. Might be a tad humid in the kitchen-next to the sink..........

Thanks,

Edward

Re: more cutting board questions

#4

And...

Bill Houghton, Sebastopol, CA

as the inevitable cracks opened up, you'd get food in them that couldn't be cleaned out easily.

Simple is better.

Re: more cutting board questions

#5

Re: And...

ThomD

I guess you could make the case for a frame in this instance, because your boards are pretty small and could be fragile. You could do a frame a number of ways. One would be to make the frame with a groove inside it, like a normal picture type frame without a back. Then make the whole block with a tenon around the whole perimeter. That way the block would float in the frame. Basically just like a frame and panel except with an endgrain panel, and a lot of dimensional differences to create more of a cutting board effect.. Another way, would be with more of a modern look. Make a groove around the cutting block, and float a frame inside it. A nice contrasting colour, I would make it no more than 1/3rd of the thickness. Problem would be controlling splitting, but if the parts were strong enough it might work and the problems with food in gaps would be much less. Another way would be to stabilize the frame with pins only. That would allow it to float and move without as many structural issues. If you chose to leave a good sized gap around the frame, stuff would just fall through.