We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
I couldn't find a decent cheese cutting tool in the stores, so I had a blacksmith friend of mine make me this frame, copied from an artifact. The handle and the wire were missing on the original. Curly maple handle finished with hemp seed oil and a piano wire blade with zero teeth per inch, or is that gullets per inch, none of those either. The cheese is hard Parmesan.
The engineer in me sees that saw not being able to cut the last 1/4" or so down through the cheese. Must make for unsightly cut ends. Now you see why I tend to leave the engineer behind when I go into my shop.
Nice rig Stephen. I need to make one for my 18th century reenacting kit.
The handle should be higher and the piano wire should be attached at the very bottom of the two vertical struts. The frame could be a simple U shape with the handle attached with enough clearance on the underside for fingers and so the fingers don't touch whatever the cheese is being cut on.
Or, the cheese cutter in the picture could be used to slice the cheese off the top or side while holding the block of cheese in one hand and slicing with the other. When the block gets to where it can't be sliced, ya just shove the remainder in your mouth and eat it.
It works fine just turn 90 degrees. When I was young I remember a similar device made up by bending wire to approximate the shape of Steven,s wonderful recreation.