New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Plane parts repair

Posts

Plane parts repair

#1

Plane parts repair

Doug Trembath

Hey, all...

I dropped my #75 bull-nosed rabbet plane yesterday, and broke the wedge / lever cap. It appears to be pot metal. Is this a good candidate for silver solder rather than brazing? It's a pretty delicate repair, and it's been many a year since I was welding and brazing cast iron.

Any thoughts?

Thanks, all...

Doug Trembath

Re: Plane parts repair

#2

Moses Yoder

Re: Plane parts repair

Moses Yoder

It seems to me it would still do the same amount of damage to any cats you throw it at without going to the bother of repairing it. ;) Honestly, I think I would look for a different one on da 'bay. They are pretty inexpensive. Trying to weld thos delicate little pieces back together would be a rather difficult job, especially to make sure the nose aligns with the sole after repair. I found a nice Preston model bull nose rabbet at a tool meet that is much nicer than the #75. I bought some thick rubber mats to put on the floor to rpevent tool breakage.

Re: Plane parts repair

#3

Looks like you can still buy them new from Stanley *LINK*

Bill Houghton, Sebastopol, CA

See the link below. Shipping from this source is sometimes pricey, sometimes not; I haven't figured out how to tell, but you can do the shopping cart thing, let it calculate shipping, and then decide.


http://www.stanleytoolparts.com/planes-rabbetplanes-12-075bullnoserabbet.html

Re: Plane parts repair

#4

Re: Looks like you can still buy them new from Sta

Doug Trembath

Thanks, Bill. In my myopic world, sometimes the obvious is occluded by my pre-conceptions. :\

I'll order one.

Doug

Re: Plane parts repair

#5

Re: Looks like you can still buy them new from Sta

Bill Houghton, Sebastopol, CA

Stanley's not very good about making their parts supply obvious. And for a lot of the tools, the parts available are what they still happen to have in the bins; so you'll find a plane, for instance, for which they have the depth stop available, but not the screw that holds it on.

Re: Plane parts repair

#6

Replace it... *LINK*

Scott Burr in Ben Lomond CA

With a new and better plane. The 75 is pretty much a worthless plane IMHO. It's uncomfortable to hold, hard to adjust because the front sole is not coplanar with the sole of the body. As Moses says it better used to chase vermin from your shop. I get a old Record or a new one of these:


A decent bullnose plane