New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Disston saw rehab

Posts

Disston saw rehab

#1

Disston saw rehab

Steve Kirincich

I have recently joined the legions of Neanderthals energized by the idea of rehabbing a vintage Disston backsaw. The split nuts and the threading on the shank of the medallion are in poor shape. I am considering sliding a brass tube over the mangled threaded shank, fixing it place with epoxy, and cutting threads into the tube. I think the split nut can be either re-tapped or just replaced with a homemade split nut. Any thoughts? Thanks.

Steve

Re: Disston saw rehab

#2

Re: Disston saw rehab

Kenneth Martin Sacramento

If you use the tubing I think I would solder rather than use epoxy. It will give a better bond.

Good Luck!

Ken

Re: Disston saw rehab

#4

If it were me

Bob Hackett

Rather than trying to restore the mangled threads I would just cut the threaded portion off and replace it by silver soldering a new threaded shank cut from a bolt onto the medallion/head .If the split nut is also damaged consider moving up to the next size tap and drilling it out the next size up.If there`s no room and you must go back with the same size then drill it out,sleeve and silver solder then tap the sleeve.

I think you`ll find that epoxy will not hold near as well as silver solder and is prone to failure across small areas of coverage where solder is not and if you`re rehabbing tools Silver soldering is a relatively easy to master skill that will serve you well on this slippery slope.

Re: Disston saw rehab

#5

What Bob said.....

Marv