New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Kenyon sash saw - picture and measurements...

Posts

Kenyon sash saw - picture and measurements...

#1

Kenyon sash saw - picture and measurements...

John Aniano in Central NJ


Hello All,

I had time the other day to make some measurements of the Kenyon saw I recently acquired. The coarse overall numbers were taken using a tape measure. The smaller dimensions such as handle and spine thicknesses, were measured using an inch dial caliper. The blade thicknesses were taken using a 1" capacity B&S micrometer. If I have access to a larger micrometer, say a 3" capacity, + some small gage blocks, I can determine more fully if the blade is taper ground.

Some general observations:

There is a definite taper to the spine height, from 0.935" at the handle down to 0.885" at the toe.

Also, I was surprised that the screw-driver slot in the brass split nuts had a width of only ~0.022"! The slot of one nut is mangled, but the other is only a bit fouled up and clearly shows the very narrow driver slot.

Note - there is some indication of possible taper grinding in the (3) toe measurements taken. I'd really rather do a better job of measuring this if I can get (borrow?) a larger micrometer.

I still have to create a better image of the handle for Dominic to make an accurate handle pattern. Give me a few more days to come up with some suitable graph paper...

Over and out,

John

Re: Kenyon sash saw - picture and measurements...

#2

Re: Kenyon sash saw - picture and measurements...

steve mackay

I NEVER noticed that spine height changed along the length. Now I'll have to scope mine out. Learn something new every day !

Re: Kenyon sash saw - picture and measurements...

#3

Re: Kenyon sash saw - picture and measurements...

Marv

Steve,

Seems strange for the back to be wider at the handle end than the toe end. Can't imagine what the purpose would be.

Let us know if yours is tapered too.

Thanks,

Marv

Re: Kenyon sash saw - picture and measurements...

#4

Stephen Shepherd

Nice Documentation   

Stephen Shepherd

Re: Kenyon sash saw - picture and measurements...

#5

Re: Nice Documentation

Dominic in Buck

Wow! I agree. Nice job on the documentation!

I can't wait to get a crack at drawing up that handle.

Re: Kenyon sash saw - picture and measurements...

#6

Re: Kenyon sash saw - picture and measurements...

steve mackay

I layed a caliper on my pre-1900 Sikes & Son and the two dimensions are 'bout the same the whole length. maybe a bit thinner at the end but I don't think its enough to be intentional. Maybe it was an effort on Kenyon's part at "new & improved" ? Or another mystery like nibs ? :)

Re: Kenyon sash saw - picture and measurements...

#7

Re: Kenyon sash saw - picture and measurements...

Marv

Or just shoddy workmanship? Oh my gawd, did I say that out loud? :O

Marv