Refurbishing an Old WW Vise
John McGaw
I was given an old cast-iron vise marked "The Columbia Vise & Mfg. Co", "Cleveland Ohio U.S.A.". Vintage is unknown but it clearly isn't new and it has seen some abuse. The big problems are rust and dirt, a quick-release on the screw mechanism which doesn't do much of anything (except to release when it shouldn't) and a front "finger" (or whatever that little bit is that is supposed to rise up above the front jaw to enable clamping a workpiece between it and a bench dog).
I've never restored any old tools but would like to tackle this as a learning experience. Dirt and rust can probably be taken care of most easily by media blasting and repainting; or if this will ruin some inherent antique value perhaps there is another way to tackle it. The quick release situation is unknown but opening up the housing will probably tell the tale but it is possible it is nothing more than something stuck in place by rust.. And the stuck "finger" will probably yield to some penetrating oil and patience. Does this sound like a plan or am I heading for disaster and ruin?



