New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Odd Bit Brace Chuck - holds flat bits not square

Posts

Odd Bit Brace Chuck - holds flat bits not square

#1

Odd Bit Brace Chuck - holds flat bits not square

David Miller from Iowa

Picked this up at a sale yesterday - Was going to pass it up because of damage, but I glimpsed the odd chuck hole - it is 5/8" long and 1/4" wide. Have you seen this or even any bits for this? What gives?

Re: Odd Bit Brace Chuck - holds flat bits not square

#2

Re: Odd Bit Brace Chuck 2nd picture

David Miller from Iowa

Here is the whole thing

Re: Odd Bit Brace Chuck - holds flat bits not square

#3

Re: Odd Bit Brace Chuck - holds flat bits not squa

Bill Houghton, Sebastopol, CA

I have a similar looking brace, though not with the added rust feature that yours has (I'm jealous), but it takes conventional tapered square bits.

Yours may be the product of someone's ingenious plan to revolutionize the auger bit industry, yet another failed business endeavor.

I know old taps sometimes had flats instead of the squared-off shanks of modern taps, and, if you look at the design of most tap wrenches, you'll realize (as I did AFTER passing on a whole bunch of flat-shanked taps) that you could put such a tap in the wrench. But a brace is not the right tool for use with a tap - I think it would be hard to keep the force centered properly.

Re: Odd Bit Brace Chuck - holds flat bits not square

#4

Re: Odd Bit Brace Chuck - holds flat bits not squa

Dale Warder

David, I obtained a small group of bits with a flat tapered shank which look like they would fit such a chuck. These were in a box lot of junk I purchased a couple of years ago. As the bits were obviously produced with this shank, such a chuck must have been available at one time. Tomorrow I will try to locate them and see if there is any further information.

Dale

Re: Odd Bit Brace Chuck - holds flat bits not square

#5

Stephen Shepherd

Re: Odd Bit Brace Chuck - holds flat bits not squa

Stephen Shepherd

David,

Flat tang blades were common in the 18th century and earlier and the braces were made to hold them. Some were permanently fastened into wooden chucks that fits wooden braces. Yours is probably a late 18th or early 19th century version. I have one that holds both flat tang and square tapered bits that probably dates a bit later than yours. Nice find. Now you need to make a split turned handle and get some flat tanged bits.

Stephen

Re: Odd Bit Brace Chuck - holds flat bits not square

#6

Michael

Re: Odd Bit Brace Chuck 2nd picture

Michael

David,

I have found several braces like yours at flea markets here in Germany. I don't know if they were German or French or just "continental." I've found some older style shell bits that use the flat shank. I've also found one brace with a combo chuck that will accept square or flat tangs.