New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Ya know those hangie downie thingies...

Posts

Ya know those hangie downie thingies...

#1

Ya know those hangie downie thingies...

Scott Burr in Ben Lomond CA

On the underside of blanket chests lids? As my blanket chest comes to a close, I have the top flattened and beveled to my liking. Being a Shaker inspired piece I have the following questions. Is there a ratio on where to place them on them lid? How wide and how thick? It looks like their screwed into place, yes?

Thanks!

Re: Ya know those hangie downie thingies...

#2

Your technical terminology leaves me in the dust

Bill Houghton, Sebastopol, CA

No idea of what you speak, Scott.

Re: Ya know those hangie downie thingies...

#3

Re: Ya know those hangie downie thingies...

Bob Hackett

I think he may be asking about hinge spacing???

Re: Ya know those hangie downie thingies...

#4

OK, that didn't work...

Scott Burr in Ben Lomond CA

That's what I get for being a smart arse :D

Actually I'm talking about the battens on the underside of the lid as seen in this photo. This is not my chest, Jerome is the person that made this one.

So I was wondering about the placement of the battens. Also these are screwed on and I'm worried about the movement of the top. Should the holes through the battens be oval or obround to allow for movement?

My top is 22"X40"

Thanks!


Re: Ya know those hangie downie thingies...

#5

Re: OK, that didn't work...

Joe Rogers, Northern Virginia

Oh...you mean the strap hinges!

JR

Re: Ya know those hangie downie thingies...

#6

Battens

Warren in Lancaster, PA

A wide board like you have for the lid of your chest is vulnerable to cupping from seasonal humidity changes. A heavy molding or a breadboard end on the lid will help to restrain the movement. Battens also are used for this purpose. For outside battens like the chest you show, I would make them the same thickness as the chest or maybe 1/16 less and nearly twice as wide as thick. The width (height) is what will restrain the top. I would mount the battens 1/8 or 1/4 inch from the ends of the lid and also leave clearance for closing the chest. Some chests like this have instead battens about three inches from the ends so they don't show when the chest is closed. Something like 7/8 x 1 7/8 lying flat under the lid. Old chests often have battens nailed, but I would screw them on and make a slot or pretty good sized hole for seasonal expansion.

Re: Ya know those hangie downie thingies...

#7

Re: Battens

Bob Hackett

An alternative would be a sliding dovetail to both attach the batten and allow for wood movement.