New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

OT - in my e-mail

Posts

OT - in my e-mail

#1

OT - in my e-mail

Bill Houghton, Sebastopol, CA

This morning, I have three e-mails from one Chris James, who wants to order a "14" 100 Tooth Steel Cutting band Saw Blade 1" Bore."

I wish I could help the poor guy out - he sounds really desperate; I mean, THREE e-mails? Unfortunately, the equipment in my shop can't do more than a 7/8" bore on bandsaw blades. Now, if he wanted a 1/4" by 133" circular saw blade, skip tooth...well, actually I couldn't help him there, either.

Re: OT - in my e-mail

#2

Trying to form an image in my mind

Marv

Bill....

I can't seem to picture that blade in my mind.....could you by chance draw a sketch and post it? :D

Marv

Re: OT - in my e-mail

#3

Maybe this will help *LINK*

Bill Houghton, Sebastopol, CA

If you assume the 14" is blade length, as is customary with bandsaws, and if you picture the blade laid out on the floor in a circle, you'd wind up with a circle just under 4-1/2" in diameter. Subtract 1" for the bore the customer requested, and you need bandsaw blade stock roughly 1.75" thick.

It's hard to find bandsaw stock that thick that's still flexible enough to pass over a 1" wheel.

I think I just won't follow up on the order request. Maybe I should refer him to Lee Valley - some of their products meet the same kind of "extreme specifications" standards required here - example linked below.


Lee Valley's low angle jack of several years back

Re: OT - in my e-mail

#4

Re: Maybe this will help

Marv

I know there's a lot that I have not seen yet, but no way can I imagine a bandsaw blade running on a 1" diameter wheel no matter how thin the blade is. It would have to be a very small band saw to have a blade that is only 14" in circumference.

Marv

Re: OT - in my e-mail

#5

Re: OT - in my e-mail

Sandor in Middletown, DE

I think maybe he means tablesaw blade?

14" diameter, 100 tooth blade capable of cutting steel, 1" arbor hole.

Who is cutting steel on a tablesaw? I have cut through nails (not on purpose) with carbide tipped blades.

Re: OT - in my e-mail

#6

I think maybe he...

Bill Houghton, Sebastopol, CA

along with the other scammers who've got my e-mail and know that I do woodworking, has no idea what he's talking about but is throwing out random WW related words in hopes that he'll catch the occasional fish. This one was somewhat more random than most I've received, and I thought the phrase was kind of entertaining.

Re: OT - in my e-mail

#7

Re: OT - in my e-mail

Phil Joines

I have a Forest 10" steel cutting TS blade. It's carbide, about 60 tooth. Haven't used to for steel, I think the RPM's are different, but it cuts MDF really well.