New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

One good whuppin'

Posts

One good whuppin'

#1

One good whuppin'

James Watriss

So, I took today to rehab my Sjoberg Elite bench. I've posted some of my complaints about the bench in here before... mainly, that the pre-fab drawer setup needed work, and that the top had bowed. Well, it was time to get it back in order today.

Bearing in mind the wisdom of 'teh Schwahtz," re: appropriate bench heights for planing, I probably should have chopped it down to a lower height before planing the thing down to flat. I think that when I started, the center of the 8' long monstrosity was somewhere between 1/16-1/8" higher than the ends. That's a lot to take off, and that's without the subsequent chasing around for an actual flat surface.

Hours and a lot of sweat later, it was flat. I ran a sander over some of the few rough spots, to make them a little less rough, and coated the top with the bench oil that it was packaged with 3 years ago.

Ugh... I'm in no hurry to do that ever again.

Note the blast radius on the floor of all the shavings...


img

Re: One good whuppin'

#2

How flat is it?

Marv

Re: One good whuppin'

#3

Flatter than the last inch of coke in the bottle

James Watriss

I had that guy from woodnet flatten it to within .0001"...

Just kidding.

It's hard to accurately gauge. My short straight edge is a starrett 24" combination square blade. My long straight straight edge is a 6' aluminum Borg ruler. My thickness gauge was a scrap of some yellow legal pad. Given that the bench was *wildly* out of flat before, I'm pretty happy with it now.

I can say that it's not wound, and that the ruler used to register a serious crown in the middle that no longer registers.

I'll let the bench settle out a bit and see if it's stabilized after being out of the box for 3 years. I doubt it, but I can hope.