New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Help with Unidentified Glue Removal?

Posts

Help with Unidentified Glue Removal?

#1

Help with Unidentified Glue Removal?

Tom MacGregor

A neighbor asked if she could "borrow a couple of the right kind of clamps" to glue a cracked headboard and I suggested that bringing it to my shop might be the easiest thing to do. I was stunned when she showed up with the headboard from an early 19th Century rope bed made of magnificent birdseye maple - including the frame & panel board and four inch diameter posts! Every glue joint had failed in the frame & panel, so that's going to be easy to clean and repair. Above that the top of the headboard is a single piece of 7/8" thick maple 14" wide that has cracked along it's entire length twice. The newest crack is clean enough to glue up without much trouble, but an older similar crack was poorly repaired (not lined up well) and has failed across about half its length; the rest is still tight.

I'd like to disassemble the older crack, but pulling the loose side open a ways did not make the rest fail. I think from the small amount of visible squeeze-out that it's modern white glue but can't be 100% sure. Any suggestions on how to proceed would be appreciated.

Re: Help with Unidentified Glue Removal?

#2

Jack Guzman from Maine

Re: Help with Unidentified Glue Removal?

Jack Guzman from Maine

If the crack is in a straight line I think I would finish the separation by cutting it with a bandsaw. Then I would clean up both edges for regluing.Using this method you might lose about 1/8" in total width. Depending on how much material you have to remove to true up the edges. In my experience regluing cracks like yours tends to fail unless you can get both edges clean and still fitting together well.

Hot water helps in removal of yellow and white glues.---Jack

Re: Help with Unidentified Glue Removal?

#3

Steam for PVA

John in NM

Might have to use boiling water to get the crack apart, once you do, use steam and careful scraping to remove all the old PVA before re-gluing. Trying to glue PVA to itself will fail, guaranteed.

The older stuff is probably hide glue as you no doubt know. You can look at the cracking pattern to tell for sure. Cracks into small rectangles I think... I'll ask sis, she's stopping here on her way home this evening, and she'll probably remember.

Hide glue should stick to the old hide glue ok, so the joints won't be excessively loose from vigorous glue removal. It'll probably fail again in 100+ years, but that's somebody else's problem. The only hide glue joints I've fixed were all too loose to begin with, that's why they failed.