What kind of hammer?
David Miller from Iowa
Still sorting through my auction stuff. For what use is this hammer? Marked Vaughn & Bushnell Chicago

Knowledge You Can Build On — Est. 1998
What kind of hammer?
David Miller from Iowa
Still sorting through my auction stuff. For what use is this hammer? Marked Vaughn & Bushnell Chicago

Pointy-peen hammer
Bill Houghton, Sebastopol, CA
You know, ball peen, cross peen - pointy-peen.
Actually, although what I know of blacksmithing could fit on a 3x5 card using Magic Marker, it looks to me more like the tool you strike with a hammer to create a shape in hot iron while it's held on the anvil. Is the term top fuller? Can't recall (see 3x5 card). The length of the body on the flat-face side; the short handle; and the serious mushrooming of the flat face all lead me that way. Plus, it'd be a bear hitting anything accurately with the pointy-peen side.
Blacksmith`s top tool
Bob Hackett
That is a handled top tool(as in used on top of the anvil) and does the same job as a countersink.
You get the steel hot,punch it with the proper punch and then use that top tool driven by a hammer to countersink so you have some place to peen a rivet into for a flush fit,like on the back of a riveted bracket you`re going to screw to a post.
Drift or Punch
Stephen Shepherd
Bill is correct in that it is not a hammer per se it only resembles a hammer. The handle is too short for pounding but holds the punch/drift in position when it is struck with a single jack. A blacksmithing tool.
Stephen
Re: Pointy-peen hammer
Larry Barrett
In Richardson's Practical Blacksmithing, if you have a copy, on page 149, figure 116 looks just like this tool. He calls it a bob punch or countersink.
So Bob Hackett should stay away
Bill Houghton, Sebastopol, CA
from Iowa? or from any blacksmith wielding this?
Actually...
Bob Hackett
I carry one in my back pocket.Comes in handy for all kinds of things. ;^)
Hi Larry, a question...
Scott Burr in Ben Lomond CA
Which version of "Richardson's Practical Blacksmithing" do you have?
I was looking on Amazon, and there a lot of different ones.
Thanks
David Miller from Iowa
Re: Hi Larry, a question...
Larry Barrett
I bought my copy probably 30 years ago. "Practical Blacksmithing", compiled and edited by M. T. Richardson. Subtitle is "The Original Classic in One Volume". Published by Weathervane Books, 1978.
Thanks Larry!
Scott Burr in Ben Lomond CA