Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Finally, I get to glote

Posts

Finally, I get to glote

#1

Finally, I get to glote

Neal in San Jose

Living in this old tools desert, I don't often find anything glotable. On th 'bay today, tho, I scored an instant egg beater drill collection!!! Check out item 330448226453 At about $7.25 each with shipping, I'm jazzed! I've been looking for a couple of good sweat powered drills, but have been put off by the price. I do own one similar to the one in the lower left of the picture but missing the side knob. Now I'm set to drill holes in everything that doesn't move!

Re: Finally, I get to glote

#2

Finally, I get to say... *LINK*

Scott Burr in Ben Lomond CA

Ahhh you know... :D

But for good measure YOU SUCK!

Too bad the breast drill looks to be a single speed, still you suck :b


Niel Scores!

Re: Finally, I get to glote

#3

scott grandstaff

Re: Finally, I get to say...

scott grandstaff

So, whats up with the second to largest one, just under the breast drill?

Looks like some kind of transmission on that one??

yours Scott

Re: Finally, I get to glote

#4

Congrats

Bill Houghton, Sebastopol, CA

The breast drill looks like a two-speed to me: in the picture showing the "back," I can see the smaller drive gear hiding, and two holes for the drive wheel's spindle - if you transfer it to the hole closer to the chuck, the smaller gear should engage.

I suspect the drill Scott asks about has semi-shielded gears. Not the full shielding of, say, a Stanley 610, but enough protection to keep small children's arms or fingers out of the works.

A nice set of drills, that should keep you entertained for ages, drilling holes. It's good to have a range of sizes, too: the smaller ones are not always good for drills above 3/16", but the mid-sizes are clunky for small bits.

Re: Finally, I get to glote

#5

Re: Finally, I get to glote

David Weaver

Other than rare matched sets, big groups are always good for the buyer and bad for the seller.

Well done.

Re: Finally, I get to glote

#6

Almost there.

Bob Hackett

Now you only need a push drill to have it pretty much covered.

You do already have braces in all the different sweeps don`t you?

Almost forgot,you suck!

I have more invested,even with shipping, in my eclectic collection and some of yours look to be in better condition.

MB