Re: Tool cabinet
Wiley Horne--So. Calif.
Hi Larry,
I was going to leave this one to someone with more experience. But it isn't happening, so I'll share what I learned from driving exactly one of those rosehead nails, with the bulge in the shank. This was to affix the tote of an olde-tyme wooden jointer plane.
The nail was maybe 1-1/2" long, not more than 2" I'm certain. It was heavy duty. For nailing into beech, I drilled a 1/8" pilot hole if I recall correctly. And it still took some heavy licks to drive it, because of the belly in the shank. Once a nail like that is in place, I would venture that it would take a tactical nuclear weapon to back it out. In other words, forget it. And it looks beautiful.
From that single experience, I would suggest thinking about where on the tool chest you'll be using these nails, and thinking through the girth and length of the nails which will best suit. You wouldn't want to be driving that heavy rosehead nail of mine into a thin section. Save them for appearance locations which can benefit from heavy holding power. Incidentally, my impression is that all these nails have considerable holding power, precisely because they are rather rough textured. Pretty sure you'll be pilot drilling for all of them.
Take the above with a grain of salt, due to my very limited experience. Perhaps someone who has driven many of these could add more.
Wiley