Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Stanley 1248 brace

Posts

Stanley 1248 brace

#1

Stanley 1248 brace

Bill Houghton, Sebastopol, CA

In my wanderings today, I picked up* a Stanley 1248 brace, which seems like a nice though unremarkable brace but with one fancy feature: a ball bearing chucks. The bad news is that, while the brace as a whole is pretty decent (rust being normal, but it's intact and the ratchet works), the chuck's frozen. Two questions:

1. Are there any particular advantages to these chucks over the shell chuck?

2. I dug around a little, hoping to find somewhere that explains how these are assembled or how to disassemble and service them; but without success, probably because I didn't know the magic words to type into Google. If anyone can help, I'll be right grateful.

Not sure how to justify yet another 10" sweep brace to myself...any help you can give me on that, too, would be welcomed.

*To get it, I also had to buy about ten bits, mostly duplicating sizes I've got, and some miscellaneous brace stuff, along with, for some reason, several cold chisels. The seller tried to close the deal by pointing out that he'd throw in the 5-gallon plastic bucket; I politely didn't tell him I had a dozen or so plastic buckets at home.

Re: Stanley 1248 brace

#2

Simpler than I thought

Bill Houghton, Sebastopol, CA

The chuck is less complicated than I thought when I first looked at it: a shell chuck, but with a rotating collar at the mouth. The jaws, which fit into a slot in the male-threaded spindle onto which the chuck screws, also fit into two slots in this collar. Thus, as the chuck is tightened, the collar rotates, reducing the friction on the jaws to simple axial friction rather than the more complex axial and rotating friction of a simple shell chuck. A lot of extra machining to achieve that.

Although the metal on spindle and chuck is bright, the chuck had frozen in place on the spindle. A little penetrating oil and pressure from a pair of pliers with the brace held in the vise (and a bit of grunting) fixed it.

Now I have to decide whether to add it to the gathering (pride? herd?) of braces already on the wall.