A tale of (2) 4-1/2s
Dominic in Buck's County PA
Ok, some time back I got a No 4-1/2 smoother I got from Ebay that looked like Cookie Monster was chewing on it. I may or may not have mentioned it here. If not, here are some photos.
Look at the lovely purple paint on the chip breaker and plane iron
You can't really see the pitting on the sole because of the BLACK paint the seller slathered on to hide it! THAT didn't show up until I soaked it in Evaporust and started cleaning it!
Here's what showed up after I wire brushed it.
This was a lot more than I had bargained for. There was no way I was going to spend multiple hours trying to get this sole smooth. First off, lapping it out by hand would be a royal hurt-fest. Secondly, if I ever sold it, I'd never recoup my labor. So I cleaned up the rest of the parts (which oddly enough came out OK), set aside the nice rosewood tote and knob and started looking for a donor body.
It was about then that Scott W from WoodNet contacted me and offered to send me a No 4-1/2 he had picked up and never had the chance to clean up. Oddly enough, it was missing exactly the parts that were salvageable from the previous beat up No 4-1/2.
So once I got it, I gave it an Evaporust bath, wire brushed the surfaces and started replacing the broken or bent parts. At the same time I took the tote and knob from the beat up No 4 1/2, as well as the knob from Scott's plane, and a rosewood tote I had repaired months ago (and never quite finished) and refinished them. All came out quite well (if I do say so myself).
Fast forward to last night where the tote and knob got their last buffing with wax and steel wool. I assembled the plane and installed the tuned and sharpened iron and chip breaker. Here's what it looks like now.
And here it is on some Ash, Walnut and finally Bird's Eye Maple
While I'm pleased with the nice full width fluffy shavings, it's really not about that. It's the finish the plane leaves behind that matters. So,...check it out!
Now here's the REAL cool part.
Remember that beat up 4-1/2 body? Well Tom B. aka:"TablesawTom" from WoodNet contacted me and wanted it so he could try surface grinding it. After some talk we decided to trade a saw vise for it. Now I have a saw vise. But oddly enough Scott W (who gave me the other 4-1/2) needed one. So I asked Scott if he wanted a saw vise, he said "Yes!" Now Tom is sending him out the vise he traded me old beat up 4-1/2 body (plus the frog) for.
As an added bonus the left over parts from the 4 1/2s are JUST what I needed to complete a Bedrock 606C that just arrived today. And that extra tote and knob now have a plane to go with! Once I add a Bedrock Lever Cap I had sitting in my parts drawer, and I clean up the sole and frog I have a complete Bedrock 606C!
Don't you love it when plan comes together?
See ya around,
Dominic






















