Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

OT: Chuck jaw springs - you wouldn't lose these

Posts

OT: Chuck jaw springs - you wouldn't lose these

#1

OT: Chuck jaw springs - you wouldn't lose these

Bill Houghton, Sebastopol, CA

In cleaning out my storage shed, I stumbled over a Cummings 1/4" electric drill, purchased at some garage sale years ago and forgotten. I found the chuck an interesting design. In the early (possibly post-war - don't know) years of portable electric tools for the homeowner, some manufacturers offered chucks that were hand-tightened, like those on eggbeater drills, with a collar on the spindle to grip while tightening.

The drill is trashed (WHY did I buy it again?), so I tried removing the chuck, which was rusted on the spindle, and it spontaneously disassembled instead, revealing one solution to the problem of losing those tiny springs that open the chuck jaws as you unscrew the chuck: bonded rubber "springs." These are still flexible after 60 or more years, kind of surprising; but I can't imagine they were very effective.


Re: OT: Chuck jaw springs - you wouldn't lose these

#2

Re: OT: Chuck jaw springs - you wouldn't lose thes

Marv

Bill,

The flexible material is probably Polyurethane used in it's resin form with a catalyst same as many epoxies. The method is being used even today to grip taps in automatic tapping heads. Polyurethane is exceptionally tough stuff and with a bonding agent will bond to metal and other materials quite well. The flexibility of resin type Polyurethane can be accurately adjusted by adding a third component to the mixture which would make the jaw assembly quite effective.

Marv

Re: OT: Chuck jaw springs - you wouldn't lose these

#3

Re: OT: Chuck jaw springs - you wouldn't lose thes

Jerry Nicholson

I have one of those - bought it in 1948. It still works but that hand tight chuck was a mess. After drilling a few holes, I had to put pipe wrenches on the chuck and the knurled collar on the shaft to get the chuck back open. Of course it is a non standard spindle size so I couldn't just put a different chuck on it. Every so often I run across it and plug it in to see if it still runs. Then I stuff it back in a drawer and forget about it again.

That drill got used a lot back in the early 50s when I was building ham-radio equipment. Modern drills are far better.

Jerry