Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Free: cast iron for diamond paste sharpening

Posts

Free: cast iron for diamond paste sharpening

#1

Free: cast iron for diamond paste sharpening

Bill Houghton, Sebastopol, CA

If there's anyone in the Sebastopol, CA area who would like a free tablesaw table top for diamond paste sharpening, I've got one. Tomorrow (Thursday) afternoon, it's headed to the recycle bins - somehow I wound up with two of them and don't need both.

It's too large to fit in a flat rate box and seems too heavy to justify shipping anywhere, although if anyone's desperate enough to pay the shipping, I'm willing to ship.

Bill, trying to lighten the load.

Re: Free: cast iron for diamond paste sharpening

#2

Re: Free: cast iron for diamond paste sharpening

Kem

Hi Bill, I might be able to use that tabletop. I will send you an email.

Re: Free: cast iron for diamond paste sharpening

#3

Re: Free: cast iron for diamond paste sharpening

wilbur

"...somehow I wound up with two of them and don't need both."

I just know there's a story in here somewhere. ;)

Re: Free: cast iron for diamond paste sharpening

#4

(Message Deleted by Poster)

Joe Rogers, Northern Virginia

Re: Free: cast iron for diamond paste sharpening

#5

Once you get in the habit of scrounging....

Bill Houghton, Sebastopol, CA

I replaced my (free, but it needed work) Rockwell 9" contractor's saw with a larger one after the first one broke. That's top #1.

Then a neighbor around the corner had a Craftsman saw on his driveway for free, with a motor. I wanted the motor, and had to take the whole saw to get it. It's slightly larger than the Rockwell's top, and laid out a little better for sharpening purposes.

Scrounging's a hard habit to break; I've been trying, lately, since I have way way too much stuff.

Re: Free: cast iron for diamond paste sharpening

#6

Cutting cast

Bob Hackett

I`ve found that the fiber type cut off blades work well for this.

Being thrifty(cheap)I use these blades on my cut off saw and then when they get too small I transfer then to a metal bodied circular saw I rescued from the dump and then when they`re too small for that I put them on my 5" grinder.

Been collecting the dust and saving it for the day I figure out how to separate the abrasive from the swarf and then I can make a paste and use THAT to sharpen with(or at least flatten chisel backs). ;)

Re: Free: cast iron for diamond paste sharpening

#7

Re: Cutting cast

Joe Rogers, Northern Virginia

Still learning the tricks on the new format...the message you responded to got deleted by mistake :(

I just suggested that the top could be downsized.

JR

Re: Free: cast iron for diamond paste sharpening

#8

I am picturing your children or grandchildren

Bill Houghton, Sebastopol, CA

puzzling over the coffee can full of iron dust in the back corner of your shop, wondering what the heck you saved THAT for.

You should probably label it somehow. "Plane tree fertilizer" or "ironwood fertilizer" sounds good.

Re: Free: cast iron for diamond paste sharpening

#9

How about labeling it...

Bob Hackett

Build your own plane kit.

Inside I could add simple instructions like;

1-add fire

2-hammer to desired shape and size

Then the the obligatory disclaimer such as;

Some assembly required

And of course,

Batteries not included. :D