Re: Tease
scott grandstaff
Thanks Y'all
I do much appreciate the kind words.
I started the project with the intent of taking a shave horse further than any had really gone before. Better geometry and working characteristics.
I wanted a dumbhead because it is definitely the most versatile head.
I wanted comfort for my carcass and some display properties for more cabinet shop precision duty, rather than out on the dirt behind the barn type duty.
With good tools and some determination, a shave horse will help you carve wood precisely, with some ease. It doesn't all have to be rough dressing shakes into shingles and such. You can actually carve wood "on purpose" when you get into it.
In use, I don't just turn the bevel up and close my eyes and yank straight back in a reckless manner.
I usually use the bevel down and start at one corner of the knife, sliding it sideways rapidly as I cut. Used this way you have incredible fine control and very little labor to do it.
If you are working too hard, you are doing something wrong!
As I went along in my original planning, I began to suspect the project was getting a bit precious and pretentious.
(the moniker Poofy Shirt Brigade was looming around the edges. )
So I decided to make sure there was no chance of that and get some fun into it at the same time.
I plain can't draw on paper. Not at all!
I did a rough drawing before I started and people couldn't even tell what it was supposed to be!
Not even the category!!
I don't allow myself to directly copy anyone, so any kind of "pattern" was out.
But I find, when I can get my hands all the way around something, full dimensional carving, well then I have a chance.
I just held my hand out and sketched it 4 times scale. Took that and sketched directly on the wood going back to my own hand for reference.
You will notice the "hand" on the horse is a right hand.
That's because my left was on the pencil!! 
Oh, yes,
the black walnut keys go all the way through the laminated beam sides and the full shoulder of each leg.
The beam is hollow in the center (the horse is heavy enough to move as it is, I can pick it up and carry it, but barely)
but not where the keys attach.
There are strips of mahogany and tiny thin strips of black walnut (most I could afford) in the beam,
just to keep it from looking too dull and one-color boring.
And, 4 big lagbolts for each leg, plus glue blocks, are =really= what holds the legs on. 
The double dovetail keys?? just needed to be there, I don't know.
hehehehehe
yours Scott