Dave Barnett
Eric
I'm looking to make some rasps. I copied this from a previous post, and I'd like whatever info you can share on the subject.
Thanks.
"Finally, you could try making a rasp or two on your own. It's far easier (and kinda fun) to make a fine cut rasp than you might imagine, esp. with all the hyperbole and high prices from rasp manufacturers. You can do this with a firebrick, a MAPP torch (even a cheap propane plumber's torch for smaller to medium sized rasps), and a hammer. You can stitch with a simple homemade punch (just a rod of tool steel/drill rod, a worn file, screwdriver shank, center punch, etc.). Over the years I've made needle rasps, small to medium sized straight and curved rasps, and I'm totally satisfied. They're far better than the cheaper Euro or Chinese rasps I've tried and cost next to nothing. Helps if you use a Magnivisor and vise, but you can manage without either. You can practice on brass or mild steel, if you feel the need. I promised someone in chat recently that I'd email some tips reasonably soon. Maybe I'll post them, too, if anyone's really interested."



