Re: Building the Carousel Shooting Board Fence
Derek Cohen (in Perth, Australia)
Hi Dave
Yes, you missed it. Of course it is more likely that I could have been clearer in my description ..
Two pictures: in the first I showed a template I used that marked off the holes ..

What you must remember is that the design is built around a circle. The pivot pin is the centre of the circle, and the holes lie on the circumference. So all you need to do is mark these off using a protractor (as I have on the template).
Here is the second picture. It shows the lines from the pivot pin (note that the "square" position hole is 6mm here and is enlarged to 8mm at the end to create the micro-adjustment).

Hope this clarifies matters.
Regards from Perth
Derek