Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

James Swan and Co. Extra U.S.A. Countersink

Posts

James Swan and Co. Extra U.S.A. Countersink

#1

Stephen Shepherd

James Swan and Co. Extra U.S.A. Countersink

Stephen Shepherd

I picked this up today for a buck, the flutes on the countersink have two bevels and the tang is unusual, never seen this configuration.

Stephen


img

Re: James Swan and Co. Extra U.S.A. Countersink

#2

Re: James Swan and Co. Extra U.S.A. Countersink

Bill Houghton, Sebastopol, CA

Interesting design. I suppose the extension beyond the square taper is for use with a three-jaw or other chuck designed for round shanks? Seems awfully short for good gripping, but an admirable attempt, especially compared to those later designs that required you to cut off the square taper to use the bit in a round-shank chuck.

Re: James Swan and Co. Extra U.S.A. Countersink

#3

Re: James Swan and Co. Extra U.S.A. Countersink

thomd

Is it for metal? I use the metal ones on wood, for that mater.

Re: James Swan and Co. Extra U.S.A. Countersink

#4

Stephen Shepherd

Re: James Swan and Co. Extra U.S.A. Countersink

Stephen Shepherd

Thom.

According to the literature the rose-head is for brass and other soft metals, the flat countersinks are for iron and steel and the snails are for wood.

I use the rose-heads for wood as well but they can chatter on hard and soft grain.

Stephen