Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

somewhat ot

Posts

somewhat ot

#1

somewhat ot

David Miller from Iowa

I bought out the contents of an old barn and found this interesting chain - it is about 4' long. It looks like cast steel. Is/was it possible to cast an interlinked chain? Is it an anchor chain? Thanks, David

Re: somewhat ot

#2

Re: somewhat ot

Paul M.

Hi David,

It looks to me like this might have been cast as two half-links that were then welded together. There is a distinct weld bump in the middle of the link (at the 3" point in the picture). Cool chain, but have no real idea as I'm just guessing.

Re: somewhat ot

#3

Re: somewhat ot

David Miller from Iowa

Thanks Paul - I understand your point, it does look a joint there. The picture doesn't show very well that there is a groove all round the link which I think would be destroyed by a hammer weld. And every link has one "square" corner (lower right in pic) that look like it could be a sprue

Re: somewhat ot

#4

Re: somewhat ot

Greg

I am guessing logging chain since it was not found in a nautical setting.

Re: somewhat ot

#5

Re: somewhat ot

Thomd

Fun, if not cast:

http://www.youtube.com/watch?v=JV_BBXZUHWs

Re: somewhat ot

#6

Re: somewhat ot

Marv

David,

Your question had to do with if the links could have been cast. Yes, they could have been cast in a sand mold but the links would have been connected with a sprue so the molten metal could go from cavity to cavity. After removing the sand mold from the casting, the links would have been separated by cutting off the sprues.

Sand casting is still being done, like casting pipe wrenches for example.

Marv