Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT Old Knife Question

Posts

OT Old Knife Question

#1

OT Old Knife Question

Patrick Gibbons

I have an old celluloid-handled knife with a tang stamp that appears to say Hammer and has what I think is a hand holding a hammer. I can't make out what is below this. To the right is USA (I think) listed horizontally. Does anyone know who made this knife?

Re: OT Old Knife Question

#2

Re: OT Old Knife Question

Jay Samuels

I searched "Hammer Brand" on the Net recently, and kind of inferred that it was a trademark of New York Knife Company, but didn't find anything I would call conclusive.

The Trademark Office shows it as a trademark filed by Imperial Knife Co. of Providence RI in 1945 and assigned to Taylor Brands of Kingsport TN in the 1990s.

I am sure that others can shed light on this. Jay

Re: OT Old Knife Question

#3

More to Jay's point

Wiley Horne--So. Calif.

New York Knife Co. used the 'hammer brand' and logo from 1878-1931:

http://www.allaboutpocketknives.com/aapk_stores/details.php?item=22588&store_id=805

Here is an example of New York Knife Co.'s hammer brand (use 'enlarge' function to see logo):

http://cgi.ebay.com/~NEW-YORK-KNIFE-CO.-WALDEN~-Hammer-Brand-Timber-Scribe_W0QQitemZ360240076170QQcmdZViewItemQQimsxZ20100304?IMSfp=TL100304209022r9572#ht_500wt_1065

The Imperial Knife Co. also used the same brand, and I don't know the date ranges. Here is a catalog reproduction of the Imperial Knife Co.:

http://www.collectors-of-schrades-r.us/Imperial/1941-Imperial.pdf

There may be a complex relationship between the companies....New York Knife Co. was founded in Walden, NY. There were other well-known knife companies operating in Walden in the late 1800's/early 1900's, including Schrade. Imperial Knife was founded in Providence, RI, but acquired Schrade as discussed here:

http://en.wikipedia.org/wiki/Imperial_Schrade

The 'hammer brand' logos used by New York Knife and Imperial Knife look very similar to me, so perhaps in Imperial's expansion and acquisition of assets in Walden, they managed to pick up the well-known brand (I'm speculating).

Hope this helps!

Wiley

Re: OT Old Knife Question

#4

scott grandstaff

Important point

scott grandstaff

Genuine NY was tip top quality.

Early Imperial was fairly decent cutlery, but they quickly degenerated to lowdown dimestore quality.

Is the cell solid or is it a "shell" handle??

The cheapies, generally despised and by far the most commonly found now, are paper thin sheets of celluloid wrapped around thin pressed metal. The thin metal also usually incorporates the bolsters. So the entire outside of the knife is actually one thin pressed shell on each side merely crimped by dinky taps at each end.

The earlier knives had solid nickel bolsters and solid cast/fit/polished cell.

Some of the celluloid was gorgeous.

yours Scott

Re: OT Old Knife Question

#5

Re: More to Jay's point

Patrick Gibbons

The logo on my knife looks more like the New York Knife Co logo. Thanks very much.

Re: OT Old Knife Question

#6

Re: Important point

Patrick Gibbons

Scott, mine is a peanut with very small bolsters on each end. They are separate from the brass liner. The celluloid is about 1/16" thick. They are attached with a nail (rivet) at each end and one in the back center. The celluloid is a light lemon yellow and dirty (as is the whole knife). I figure it was well liked by its owner as it has been sharpened quite a bit. Especially the pen blade. It could have been my father's or my grandfather's but my father loved to trade and collect and he could have picked it up that way. The blades still have quite a bit of snap in them.