Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Completed drawer

Posts

Completed drawer

#1

Completed drawer 

Derek Cohen (in Perth, Australia)

>The drawer for the armoire is complete, with the exception of the handles. I shall return to the handles after I have finished everything, which just leaves the top of the cabinet to do.

The drawer bottom is held in with slips on three sides and is screwed to the drawer back.


The bottom panel was rebated to fit. The non-rebated end was left 1/4" long to make removal easier (should this be needed in the future).


I needed to plane off 1/32" from one side and the tops for a good fit. The inside was given a coat of wax to balance the exterior oiled finish. Once done, a drawer stop was added, and this was the result.


A close up for some detail ...


And a look at the inside of the drawer to see the effect of using slips (remember that these are bevelled on the inside).




I am very happy with the way it has come out. The drawer bottom panel is really stiff and does not need further bracing, the drawer is light and is moving smoothly, and it fits well.

Regards from Perth

Derek

Re: Completed drawer

#2

Re: Completed drawer

Pam Niedermayer - Austin, TX

>Looks really pretty, Derek, great job; but, as you know, I have to comment on one tiny but prominent feature. Why did you put the pins so close to the edges of the stiles? Do you have a very shallow tenon?

Pam

Re: Completed drawer

#4

Re: Completed drawer

Derek Cohen (in Perth, Australia)

>Hi Pam

The styles are 2" wide and the stub tenons are a little over 1 1/4" deep.

I have been collecting a lot of pictures and detail and will get this when I have time. One of the pieces will be on drawboring, and I will then be able to show this area to you.

Regards from Perth

Derek

Re: Completed drawer

#5

OK, thanks.

Pam Niedermayer - Austin, TX