Hey -- remember that workbench I was working on?
wilbur
>It's been over 9 months since I did anything meaningful with the workbench I started building last January. I finally got around to finishing the joinery for the legs. I had cut the mortises before, but this past weekend I cut the tenons and drilled holes for drawboring.
I'm going to use double mortise/tenons to attach the top to the legs. Here you can see the hole for the leg vise screw to pass through. In the previous picture you can see the slot for the parallel guide at the bottom of the leg.
I'm sure I'm going to lose major hand tool cred points here, but the holes for the leg vise screw and the drawboring were drilled using a combination of a drill press, cordless drill, a 3/8" brad point bit, and a hole saw. Why? Because overall I kind of suck at precision drilling. 
A picture of the dry fit. The side that I'm working on will actually be the underside of the workbench top, which has served me surprisingly well as a worksurface. I probably would not have waited 9+ months to get going on this, otherwise.
And, the other set of legs.

It's amazing how much you can do if you have a holiday weekend when (1) you're not on call, and (b) said holiday does not involve eating large amounts of turkey or Santa bringing presents for the kids, in which case you also have to deal with visiting relatives. 
Next step: cutting the long stretchers and tenons. Given my rate of progress in the past, I'll have that done by mid to late April. 
(I get to use smilies now!!!)
. your'e Speedy Gonzalez compared to me. My bench seems to be stuck in place for now. Keep up the good work!


