Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Painting in cold weather

Posts

Painting in cold weather

#1

Painting in cold weather

Bill Houghton, Sebastopol, CA

>I'm trying to get the siding and trim that we put up outside our bath remodel weathered in, because we're supposed to get rain next week.

The instructions on the paint can for the (latex) finish paint say not to apply paint when it's below 50 degrees Fahrenheit. At the moment (10 a.m.), I've just finished slapping on the first coat of trim paint on the two windows, and it's 40 degrees, with the temp headed up.

Does the paint not bond well when it's cold, or is there some issue with the chemical reaction that will cause it to fail early?

Re: Painting in cold weather

#2

Jesper, Denmark

Re: Painting in cold weather

Jesper, Denmark

>Bill, primarily it is just slower in drying.

High humidity will make it worse or impossible.

Frost is a NO-NO

Re: Painting in cold weather

#3

Jim in Burlington Ont.

Bad Idea

Jim in Burlington

>When the sun hits the paint and it is not dry you can get bubbles in the paint. PITA to scrape it off and start over. If it rains before it is cured your in for a disaster.

Re: Painting in cold weather

#4

Re: Bad Idea

Victor Parisian

>a few years back I watched in awe as contractor's painted my neighbor's house in a steady rain. Never cared for that neighbor, so zipped my lips until just now.

victor

Re: Painting in cold weather

#5

Seems to have worked

Bill Houghton, Sebastopol, CA

>I got the second coat on, in what was definitely better than 50 degree weather, and the first coat had bonded well to the primer. So I guess I didn't push the limits too much.

It's possible, of course, that that side of the house was warmer than the north side, where the outside thermometer is.

Re: Painting in cold weather

#6

why it doesn't work- latex paint chemistry

Bill Tindall

>I have posted numerous times how latex paint works but here it is again.

Latex paint is a suspension of micron sized plastic balls in water called a "latex". The balls are swollen with solvent to make them mushy. The paint gets spread and the water evaporates leaving behind the mushy balls. If the temperature is high enough the mushy balls coalesce into a film. Finally, the solvent evaporates leaving behind a "cured" film. If it is too cold the balls will not be sufficiently mushy to coalesce and you won't have a properly formed film. Its resistance to stuff will be compromised.

Re: Painting in cold weather

#7

Re: why it doesn't work- latex paint chemistry

ThomD

>Cool explanation Bill!

That raises a few questions:

Is the typical latex primer the same chemistry?

What happens if the the paint sits there in the cold for a while followed by a rise in heat?

Re: Painting in cold weather

#8

answers

Bill Tindall

>Latex primer is a "latex" as previously described. It is formulated different from top coat to promote better adhesion. Need to ask Dresdner on main board for more detail as I am not a paint chemist.

The problem with painting cold and hoping for coalescence upon warming is that the solvent that makes the particles mushy will be evaporating while everything is warming up. By the time the particles get warm enough to coalesce they may not have enough solvent left to enable them to do so.

\Bottom line is that it is very risky painting latex paint below the recommended temperature because the final film properties can be compromised. At worse the film will be grainy and have poor adhesion.