Planing stop gizmocity
Bill Houghton, Sebastopol, CA
>I picked up a commercial planing stop at a garage sale Sunday, and it reminded me of the one that I've had in my jumble box for I don't remember how many years.
I hadn't installed the one I had (pictured at left below) partly because the must-do/round tuit ratio has consistently been tilted toward the must-dos and partly because it looked awkward to raise/lower the stop - it appeared to require either bashing with a hammer to raise and lower it or pressing against spring pressure with a screwdriver.
This new stop, pictured at the right below, doesn't resolve the first problem, but it's got a far superior raise/lower mechanism. The screw visible at left on the stop presses against the pivoting casting (hereafter "clamp"), which presses against the stop, clamping it in place. A finger on the clamp continues into the center of the hollow stop to support a spring, which serves, when the screw pressure is released, both to pop up the stop and to push the clamp away from the stop.
I'll be interested in experimenting with this, when the round tuit supply is sufficient - whether it's more convenient than just popping a bench dog in, I'm not sure; but the experiment will be fun, and it's definitely got high gizmocity.




