Re: help with some spalted hackberry.
Wiley Horne--So. Calif.
>Victor,
That is a stunning piece of wood. Never seen hackberry before--is it really as white as holly, like the photo shows? Would you have these drawers looking out of a dark case? Jewelry box comes to mind, ebonized something, with a small Shaker type ebony pull for each drawer.....Would you cockbead the drawers, and if so, in the hackberry or in the case material? It's an interesting project.
If it were me resawing it, I would use a bandsaw and would set it up so it would saw 3/32" on scrap. Face joint the front and back faces. Take one 3/32" slice, which gives you a smooth face and a sawn face. Then face joint the stock board again, and take another 3/32" slice, so now you have two slices, each with a jointed face and a sawn face. And so forth. You get however many slices you get--an expert could do thinner than 3/32" prolly, but I would feel confident at that thickness, allowing for the need to handle the wood without it falling apart, and also the need to plane/scrape the sawn side once it's glued on. Maybe you end up 1/16" finished thickness. When you glue up, glue the smooth face to the drawer front stock--the sawn face is the appearance side. Then plane the sawn face. I wouldn't do that gluing til all the dovetail joinery was done though.
You get however many slices you get. And that defines the number of drawers you can make.
I'm curious how thin others would saw that wood.
Beautiful piece of drawer front veneer!
Wiley