Parallel action pliers, et al *LINK*
David Barnett - SW FL Gulf Coast
>Often, especially when working on flat and softer materials, the problem is the angular compression of standard-jaw pliers. While copper, as Bob H. suggests (and my favorite for sheer gripping power - vise jaws, too), nylon or brass can improve things, the tool I most reach for: parallel plies, lined or otherwise.
They are offered in several widths and tapers, flatnose or chainnose, grip firmly and eliminate pinch distortion. I don't know how I'd get along without them, whether for jewelry or toolmaking.
Made-in-England Maun are the best but cost twice as much as the newer Valor pliers, which are pretty good (see link). Rubber cement helps to hold soft jaws in place and is easily removed.
Glass-breaking pliers for the larger stuff work nicely. Stained glass suppliers carry these.
Many metalforming pliers have nylon jaws, but these are often too thick for my needs, so I often line jaws with thin goatskin (workgloves are a good source). To avoid scratches on very soft materials (fine silver, high-karat golds, soft plastics). silicone tape is good, and silicone glue/caulk for glass and tile can makes custom-shaped jaws (best use cheap stainless steel pliers as the acetic acid can bite high-carbon). Another tip is to lightly radius and polish the edges of plier jaws.
It's rare that I reach for serrated pliers unless they're Vise-Grips.
Contenti carries Valor and Maun brands