Re: knive advice
scott grandstaff
>Well, I thought it was getting to be too much and we would move to another subject by now. So here is the last from me.
Lets see, to pull in another thread, Utica was in business for a long time and made several lines (qualities) of goods. If you can cut the blade easy with an old used file, it was made for guys who would be prying out nails more than thin slicing. A knife for everyone.
Advise from the clerk at a retail outlet who mostly sells socks?? heeheheheheeh
"Stockman" means square bolsters and three blades, usually always one of them a spey blade. This pattern has some leeway, (they all do), but basically its the square bolsters on the handle and spey that make it a stock knife.
If rounded bolsters would be acceptable and 2 blades?? Well that is a jack knife and just look at the pattern myriad of jack knives!! Anything you could want.
Todd is nobody's fool, not by a long shot. The names Cattraugus and New York knife are some of the top names of all time. Vintage knives by these names, among a very few others, will be right at the best cutlery man has ever produced in a factory setting. Nothing, and I mean nothing at all, currently being produced, compares.
"The Quill" they used to say.
Retail offerings is where we all start. Until we find better. Much better and for less money if you're sharp.
Custom knifemakers of course are willing to put more time into it, so the highest grades of all, will always be custom.
Bernard Levine wrote the best knife book I ever read, hands down. He did about 4 editions before his publisher ripped him off and fired him from off his own book!! (never considered such a thing possible but it happened) and someone else was hired to take it over.
Forget the price lists in the later editions. Get an earlier volume.
For the very beginner, just making handles, try this guy
http://stores.ebay.com/PremiumKnifeSupply.
If you camp out on his listings you can get a blade for under 10 bucks that will make a decent knife. There are lots of better blades available, but nothing I've seen cheaper that you can still be proud of to "cut your teeth on".
There is a knife club somewhere around you. Knife collectors could swallow tool collectors in numbers. There are clubs and books and meetings and conventions, newsletters, auctions.. all of it. All told considerably more members than tool guys. Start looking around even a little and the world opens up very wide indeed.
yours Scott