Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

chisel handle

Posts

chisel handle

#1

chisel handle

Lee Herbert

>My favorite chisels are some old Stanley 750's. The problem is that the handle on one of them will not stay in the socket, no matter what force is applied in use. Is there anything that I can use or do to keep the handle on that is not "permanent"?

Re: chisel handle

#2

scott grandstaff

Re: chisel handle

scott grandstaff

>First and easiest is to check the length of the tenon. It is probably bottoming out in the socket and taking 1/16" off will let it drop on down, and it can bite.

The second most likely possible reason is the shoulder on top of the tenon needs to be shortened a little. Take a file and work it around, again removing a generous 1/16.

These two work about 97% of the time.

yours Scott

Re: chisel handle

#3

To add a bit

Bill Houghton, Sebastopol, CA

>You want a gap between the shoulder on the chisel handle and the socket of the chisel.

Re: chisel handle

#4

Re: To add a bit

George M

>If the above doesn't work, try a dab of marine sealant to the handle and insert it in the socket and let it sit for a while.

I have found that this works good and it is reversible.

George

Re: chisel handle

#5

In the archives or articles...

Bob Hackett

>You`ll find an article by Bob Smalser that pretty much covers all you`d need to know about fitting,care and feeding of all things chisel,especially socket chisel.

He uses epoxy to keep the chisel socket locked to the handle.Makes sense as alittle heat(not enough to discolor the socket unless you`re careless)will cause the handle and chisel to part ways if the wood is damaged and needs replaced.

I`ve used this technique only on loaner chisels but it works well there and I have no complaints.

MB

Re: chisel handle

#6

Re: chisel handle

Lee Herbert

>Scott:

Thanks, I'll give both a try.

Lee

Re: chisel handle

#7

Re: To add a bit

Lee Herbert

>To all- Thanks for the great suggestions, I will give them a try!