Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Using shellac in cold weather?

Posts

Using shellac in cold weather?

#1

Using shellac in cold weather?

Denis Ch�nard, Orl�ans, Ont.

>Not a hand tool question per se, although I intend to use a brush, so I guess that's a hand tool Q after all :-)

It's getting colder up here, we get in the twenties at night. I have this project that I would have liked to finish before assembly (a bookshelf), but circumstances dictated otherwise.

Since I don't want to use solvent-based finishes in the basement shop, I was thinking of finishing the bookshelf in the garage. With the low temperature shellac should set more slowly, allowing to brush it like a varnish under normal circumstances, without the lap marks that plague brushed shellac in normal weather. At least that's the theory.

Does this sound like a good plan? How cold can I go and get the shellac to apply properly? The shellac and the bookshelf are already in the garage, so there shouldn't be any problem with temperature differentials between project and finish...

TIA,

DC

Re: Using shellac in cold weather?

#2

finishing indoors- why not?

Bill Tindall, E.TN

>While in these times it may seem to be a problem using a solvent based finish indoors we should be reminded that up until not long ago any interior construction was finished (painted, varnished or shellaced) "indoors" without concern or problems. If it was in the winter, which included most months in the frozen north, this finishing would have been done with the building closed up and heated to enable varnish and paint to cure in a reasonable time. Given some reasonable care to avoid exposing concentrated vapors to an ignition source I would not hesitate to shellac, by brushing or padding NOT spraying, something in the shop. Nor would I hesitate to varnish a floor.

That said, I finish all year round. If it is not unreasonably cold I will apply (I spray) the finish outdoors, flash off much of the solvent outdoors, and then bring the piece inside the house to harden. Alternatively, if the piece is small and it is sunny, I will put it in a car, which can be very warm on a sunny day, even in the winter. We used to have a van and it was like a greenhouse in the winter- a great place for curing finish.

I don't have any experience with shellac hardening in cold conditions. There are some subtle issues that could affect the process but if I had to guess I would guess the finish would eventually harden ok, but slowly. Some finishes definitely won't work when cold. The cure rate of varnish is extremely slow if it is cold and water based finishes won't coalesce when cold, leaving an poor film.

Re: Using shellac in cold weather?

#3

Re: finishing indoors- why not?

Wiley Horne--So. Calif.

>I very much agree with Bill. All you need is a place indoors where you can lay down a 2' x 2' sheet of plywood to take the drips from brushing on. The alcohol vapors from brushing or padding are not unpleasant and quickly disperse. At room temperatures, and at typical humidities in the low 40 percents, the shellac will dry fast enough that you can hold the board vertical in one hand, brush on the shellac with the other, spin it around in place and get the other side and edge; put on a couple of light coats while you're at it; and within half a minute it's dry enough to lean it back up against a wall or door and start another board. Just try it with a couple of the bookcase shelves and see what your experience is.

Put the shellac container where you won't kick it over, is the main thing.

Wiley

Re: Using shellac in cold weather?

#4

Re: finishing indoors- why not?

Bob Demers

>Quote Put the shellac container where you won't kick it over, is the main thing.

Sound like the voice of experience Wiley he he :-)

Who me done something like that? Nooooo, well maybe once or twice, but...

Bob

Re: Using shellac in cold weather?

#5

Re: Using shellac in cold weather?

Stephen Shepherd in the State of Deseret

>Shellac in cold weather will become more viscous, simply add more alcohol and make it thinner. Shellac has no problems related to temperature, except it melts at higher temperatures. You may have to put on a couple of thin coats, but that is always better anyway. I don't think you can over thin shellac, well to a point.

I had a friend that use to paint out door billboards in the winter time, he just added gasoline to his oil paints, it worked fine, and no he didn't smoke.

Stephen

Re: Using shellac in cold weather?

#6

"You HAD a friend"......don't try this at home

Bill Tindall, E.TN

>The past tense would be consistent with using something with a flash point of minus who knows how many degrees for paint thinner! That gave me chills just reading about it. Winter, static, spark- BOOM

Re: Using shellac in cold weather?

#7

Hear, hear, with minor caution...

Alan DuBoff

>Wiley wrote:

"Put the shellac container where you won't kick it over, is the main thing."

That gave me a chuckle...and even though I am careful, eventually I knock things over and I know I have spilled shellac before...:-/ The good thing is that it cleans up with what it cuts with...:-)

But I use denatured alcohol quite a bit, and it is annoying in a closed room. As long as you use it in a ventilated area, there should be no problem. During the winter I will try to close the windows quick, as it's cold, and it lingers for a fair amount of time...no problem, open the window a bit more and go on with things...;-)

I wouldn't want to think about not using it, because not just for shellac, I use denatured alcohol for other stuff. One such thing is to remove "Permanent Marker" ink from steel. I guess you could say it makes un-permatizes it...:-)

That said, use it safely and live a long healthy life (that is well ventilated;-) The only fear is that the environmentalists will find a way to stop the sales of shellac for some political reason. The fact that shellac is a natural resource is something I find attractive. *g*

I guess we should make it clear that alcohol is the problem, not shellac, we only mix it with the alcohol. You could knock over a bag of shellac flakes and sweep them up. :-)

Just so happens that we can only obtain denatured alcohol inexpensively...that seems odd, huh? If it hadn't been processed it would be safe enough to drink *g*, but they turn it into a poison and resell it to us without exorbitant taxes...and leaves us wondering if it's safe or not...*wink*

Re: Using shellac in cold weather?

#8

Re: Using shellac in cold weather?

Frank D. in Montreal

>Hi Denis,

I'va always had more success brushing shellac in cold temperatures. The ideal for me is around -10� (celcius), but -20�C is still good (good for the shellac, a little cold for the shellacker). You'll have to use caution between coats, depending on what you do (do you sand? if so you'll have to wait longer than at 20�C). You can bring it in after a day after the final coat for it to completely cure.

Re: Using shellac in cold weather?

#9

Gasoline

Bill Houghton, Sebastopol, CA

>There are so many additives in gasoline that I am sometimes amazed it's sold even for use in cars. Not lead, now, for some years, but all kinds of other stuff.

When you read in the early-20th-century shop notes about the use of gasoline as a solvent, cleaner, etc., I suspect it's a simpler compound than what you can get from the pumps today.

Re: Using shellac in cold weather?

#10

It's not even the right color.

Bruce, a MN Galoot

>When I pumped gas as a kid, ethyl was darn near orange.

Re: Using shellac in cold weather?

#11

And oh yeah dont forget to brush off the snow :-)

Bob Demers

>

Re: Using shellac in cold weather?

#12

Re: It's not even the right color.

Denis Ch�nard, Orl�ans, Ont.

>Yup, up in Qu�bec where I grew up, regular leaded gas was called "yellow" whereas super was called "red", based on their respective color...

DC

Re: Using shellac in cold weather?

#13

Re: Using shellac in cold weather?

Bill Houghton, Sebastopol, CA

>I understand - no direct experience - that some folks use drinkable alcohol for mixing shellac (in the States, at least, there are some high-proof alcohols available that work). If you did that, all you'd risk from finishing indoors is a contact high.

Again, no direct experience, but a thought.