I show Toshio Odate my Japanese plane, and lived!
wilbur
>(I know that the verb tense matching in the title isn't right, but there are only so many characters I can use. :@) )
From a class/teaching standpoint, for me personally the highlight of WIA was finally being able to meet Toshio Odate. I was quite nervous about meeting him in person, given his reputation for being a bit cantankerous and having a short temper if he didn't like what you had to say. I had wanted him to look at the one Japanese plane that I use all the time and show me how I could improve the set up. After his hands on session, I finally had the nerve to show it to him. His first words were, "I know that is your plane. I saw you use it before."
There was a pause, where I must have looked completely stunned. It must have been during the brief time at the beginning of the day, where I was showing some friends my Japanese plane and how it worked.
"I see lots of things," he said.
He took the plane from me. "Give me a pen."
I gave him a pen. It was then that I saw the change in his eyes. It was if he had transformed from the old woodworker jovially sharing his experience as a speaker to a role where he was the master and I was the apprentice.
He took my plane and started marking on it, except that my pen decided to stop working. "I thought I told you to give me a pen!"
"It was working earlier today, " I said.
"That was was!" he replied.
Even so, Toshio was nice enough to say that he saw I was getting decent shavings out of my plane, that there were only three areas of the plane to optimize, and that it looked like overall I had done a decent enough job setting it up. Mainly, I had almost completely optimized the bedding of my blade, and I had stopped for fear of going too far so that the blade would be seated too low in the body. All I needed to do was not to be too afraid about adjusting the bed so that the blade sat lower.
Here's a video of Toshio Odate demonstrating how to use a Japanese plane. Note how fast he pulls his plane. I hope I'm moving half this fast when I get older.
The other fun class moment for me was sitting in on Adam Cherubini's joinery plane talk. He was showing how you could reverse a rabbet plane and pull it to deal with grain reversal, "just like a Japanese plane, right Wilbur?" He then pointed me out in the audience and identified me as a "Japanese tool aficionado".
I said, "It's a good thing the dyslexia is kicking in so that your talk makes sense to me, Adam."



