Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Question About Hardened Steel

Posts

Question About Hardened Steel

#1

Question About Hardened Steel

Tom Colligan

>I own an inexpensive 'Edge Hog' Black & Decker electric trimmer for your sidewalk, etc. The blade bolts onto a spindle. I've had to replace it now and the package of the new blade reads "Hardened Steel For Maximum Durability".

Would this mean the entire blade, 7.5" long, is hardened, or just the cutting edge?

I'd like to take a Dremel tool with a cut off wheel to the old blade, now 5" long, and make a striking knife from it. Or, would it need to be heat treated. TIA, Tom

Re: Question About Hardened Steel

#2

Re: Question About Hardened Steel

Marv

>Hi Tom,

Test the hardness with a file. File the outside edge and then file the spindle hole. You'll know right away if the entire blade is hardened. It could be hardened about the same as your 5PPI crosscut saw blade. If it is, you'll be able to file both the outer edge and the spindle hole. What you will be looking for is a noticeable difference.

Some people can tell how hard metal is by grinding it. If it's really hard, you'll get white sparks, if not, you'll get orange sparks.

Marv

Re: Question About Hardened Steel

#3

Re: Question About Hardened Steel

Bruce, a MN Galoot

>here are a few sites that give good examples of spark testing:

http://shopswarf.orconhosting.net.nz/spark.html

http://www.capeforge.com/Spark%20testing.html

http://en.wikipedia.org/wiki/Spark_testing

Re: Question About Hardened Steel

#4

Re: Question About Hardened Steel

Frank D. in Montreal

>Hardened Steel could be anything. It's hard to tell what you have from the spark test, especially with cheap alloys that are found on most common hardware-store tools today.

If you were making a plane or chisel blade, I'd say spend a few bucks and buy new, good steel that you can identify, but for a striking knife it doesn't matter that much. I have very functional striking knives made from sawzall and jigsaw blades (high-speed steel, i have no idea which kind). If you really want to use your trimmer blade, try it as-is. If it loses its edge too quickly, then just torch it until it's red and quench it in water.

Re: Question About Hardened Steel

#5

Good advice

John in NM

>On all counts.

At a guess I'd say the trimmer blade is not as hard as you'd want for a ww tool (floats excepted perhaps), because its likely to strike rocks and concrete edges, so they wouldn't want it to chip or fracture. Imagine using a nice hard plane blade in an edge trimmer (shudder!).

You could probably make the blade harder as Frank suggests (after shaping of course), but you could also use an old jigsaw or sawzall blade and be sure your efforts were not going to be wasted. As they're already close to the right shape and thickness, that's what I'd do.