Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

screw size to atttache door to case

Posts

screw size to atttache door to case

#1

screw size to atttache door to case

Bob in Green Bay

>I have a nicely made doors for the front of a case - paneled so not very heavy. It has been a while since putting on doors. What size screw is best to attach to the case?

The case and door are both 3/4" thick.

I posted this on the regular message forum, but appreciate ideas from this group. I usually don't double post.

Do I use coarse thread, fine thread?

Any specific details appreciated

I would like to put them all in for final fitting but am also concerned too much in and out will weaken the screw holes. I always dab in a bit of polyurethane when finishing to "harden" the holes.

Any advice greatly appreciated.

Bob in Green Bay - still a bit of summer here

Re: screw size to atttache door to case

#2

Couple questions

Wiley Horne--So. Calif.

>Hi Bob,

Congratulations on just about being 'there'!

Just a couple of questions about the overall situation... Are the doors set into the case, basically flush with the front edges of the sides, or are they arranged some other way? Is there a face frame? Are you using butt hinges, or some other style of hinge--trying to figure out which edges and faces are receiving the screws? What is the size of the doors? What is the size of the hinge?

Wiley

Re: screw size to atttache door to case

#3

Re: Couple questions

Bob in Green Bay

>The doors are approximately 22" long by 19" wide, 3/4" thick. They have a 3" frame with a to be inset panel of 1/4" thick - a light door.

The doors site on top of the case. there is no frame on the front. The case is made from 3/4" thick stock. The reason for this is that I have found hinges that swing 270 degrees so that when I open the doors, they can swing all away around and be flush with the side.

When closed you see the front edge of the hinge (front view of case),they are 1/4" from the outside edge, directly intact with the door. You see 1/4" reveal of the case on sides and top, the bottom is not seen as the doors extend beyond and will facilitate the "pull" hence no knobs.

I have the hinges fitted to the door already, they required a 1 3/8" hole by a forstner bit to sink them into the door - that is ok already. This has the hinges tight to the door. Practice opening shows ok. I am about 1/32" tight all around, but will finish with a hand plane (lie nielson - a joy)

Bob

Re: screw size to atttache door to case

#4

270 degree European cup hinges

Wiley Horne--So. Calif.

>Hi Bob,

I had to do some looking around, because I've never used a cup hinge before. Maybe someone else who has can provide very specific info.

What I did find out by visiting a couple of different vendors, is that the manufacturers specify the screws, even though they don't generally provide them, or else sell them separately (go figure). Here are a couple of examples I found. Are either of these similar to what you have?:

http://www.hardwaresource.com/Store_ViewProducts.asp?Cat=1915

http://www.dlawlesshardware.com/eurhininsevs.html

It appears the manufacturer will specify at least whether it's #6 or #8 screw depending on cup side or arm side, but in addition may specify the screw head type.

Looks like these are always steel screws. But one thing I can say from experience is that if you use brass screws, it is good to pilot with a steel screw of the same size and thread, driven all the way. Then wax the brass screw before driving.

Wiley