Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Progress on tray

Posts

Progress on tray

#1

Progress on tray

Bill Tindall, E.TN

>as a reminder this is what I am trying to make, more of less...........


img

Re: Progress on tray

#2

Step one done, raw materials for sides

Bill Tindall, E.TN

>There are 26 separate pieces assembled into what will be this tray end. First, the light/dark banding was glued up like a butcher block and the banded veneer sliced off at about 1/8" thick. This banding strip was next glued to a backing about 1/4" thick. These elements comprise the center section of the assembly shown. The top band is a 3-ply plywood by 3/8" thick, which I was told would be more robust for fretting. It was vacuum pressed. A 1/2" wide strip is then glued on the bottom. Once the glue is hard I will thickness sand these side assemblies and start cutting the fretwork. The target thickness for the sides will be 5/16".

There has got to be a simpler way to make these parts!

Re: Progress on tray

#4

Dang, That's a lot of work...

Scott Burr in Ben Lomond CA

>Hope it all goes well Bill! Thanks for the update and keep up the good work!

Re: Progress on tray

#6

And the current count is?

Victor P

>

Re: Progress on tray

#7

I am embarassed to say........

Bill Tindall, E.TN

>but it is more than 3.