Ammonia fuming a chestnut bench base
John Aniano - in central NJ...
>Hello again,
Last week I posted construction pics of the trestle base for a "dedicated" bow making bench I've built. Here is the finishing steps I've done so far:
Wanting to have the color darker and since the base was made from chestnut (yes, several folks at the CJWA meeting last night confirmed my suspicion - it is chestnut) and white oak, a natural option was to do ammonia fuming. So, I took the plunge.
Below is pictured the very flimsy frame I made from pine furring strips and sheet-rock screws. I bought some 3 mil thick plastic sheeting at the local flea market and enveloped the entire trestle base with the sheeting to make as air-tight an enclosure as possible. I stapled the plastic to the furring strips and sealed all the joints with clear packing tape. Essentially a 3' x' 4' x 5' plastic bag that had an opening at one end that could be closed with a twist-tie.

I cut off the tops of some plastic milk jugs to create 4 shallow pans into which I poured a total of 3/4 gallon of fresh house-hold ammonia. While holding my breath, I quickly pushed these into the plastic enclosure and put a twist-tie to seal the bag. Time was around 4PM.

The color started to change quickly, darkening and getting a sort of sickly green color. Thinking I did something wrong, I phoned my friend Ray W. and he told me the greenish color was normal and that it would go brown when a clear finish was later applied. Ray asked if I had done my finishing homework - "did you make up samples to test the fuming times?" I responded "no" and fumbled for words. After chiding me, Ray said that in his ammonia fuming past, a few hours worked for him (5 or 6 hours if I remember) on his white oak projects but since I was dealing with chestnut, I should stop the fuming, air out the piece and apply some finish to see the color. I reminded him that it was only a workbench base. I thanked him, waited till 9PM (5 hours total fuming time) and opened the bag and set up a box fan to vent the fumes. I poured the remaining ammonia back into the bottles and called it a night.

By morning, the ammonia smell was gone, I disassembled the plastic and frame and took the trestle upstairs to it's new home. I put some Sutherland Welles High-Luster Tung oil onto the trestle to see the color change. One can see the unfumed section that the stretcher covered right next to a fumed portion, with finish on both.

I liked the color, so I put finish on the whole bench base. The images below show the before and after. The fuming produced a rich medium brown to both the white oak and chestnut parts. Any greenish hue had disappeared.


Other than the fact that the butcher block maple top, also finished with one coat of the tung oil, is lighter than the base
color, I'm happy with the result.
Like I keep telling myself - it is only a workbench...
When I get it fully outfitted for making bows, I'll post a picture.
John




