Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

laying out the fret work

Posts

laying out the fret work

#1

laying out the fret work

Bill Tindall, E.TN

>None of this will make any sense unless you are familiar with the earlier post about three lines below in the threads under "trellis".

The bottom "inlay" pattern was assembled as described by Wiley for the process to make banding. It is assembled like a butcher block and then thin pieces sliced off and glued to a backing piece to make the alternating light/dark bands of the bottom part of the tray side. The top to be fretted was assembled from 3 plies to make it split resistant and this assembly glued to the bottom inlay part. The bottom strip was glued on the bottom of the inlay part and left protruding to provide a stop for the marking template. Laying out the fret work pattern then became a simple matter of scribing the fret lines indexed off the alternating bands of the inlay, again as show in the picture. Now after a simple matter of precisely sawing out the openings the pattern wil be complete. Some practice may be necessary.

Many of you will recognize contributions you all made to this process.


img

Re: laying out the fret work

#2

fretting *LINK*

paul womack

>The top to be fretted was assembled from 3 plies to make it split resistant

I'm sorry - I should have mentioned that the old fret work books mention DIY ply for some pieces.

BugBear


http://www.bookfinder.com/

Re: laying out the fret work

#3

Shaping up beautifully! *LINK*

Wiley Horne--So. Calif.

>Hi Bill,

I recall Warren had the key input. That is really looking sharp. For the benefit of those without photographic memory, linked below is a photo of the tray.

Wiley


Headley tray/ mahogany and satinwood

Re: laying out the fret work

#4

Fretting, not

Bill Tindall, E.TN

>Sawing out the cutouts with a fret saw (powered) is slow but not difficult. I am doing it under a magnifying lens- one of those big things with a fluorescent light around it. It is no trouble keeping on the scribe lines. A professional offered the advise to cut into each corner and then back the blade into these cuts and cut out from the corner along the lines.

Like cutting dovetails, it is easy to cut the wrong place. From now on I will be marking the areas to be cut out.

So in the end it will be slow making this pattern but not difficult.

Re: laying out the fret work

#5

Re: Fretting, not

Warren in Lancaster, PA

>Bill, I noticed that in your layout the diagonal strips are about 30% narrower than the verticals. Traditional fretwork would more likely have them the same width. I do like your scheme also, though.

In sawing fretwork, I sometimes approach a sharp corner from both directions as you mentioned, but for 90 degree turns I generally saw continuously around the corner. It could be that the blades for a fretsaw are more delicate than for your scrollsaw.

Re: laying out the fret work

#6

geometry problem

Bill Tindall, E.TN

>By altering the making template, equal widths could be achieved. I will try it on the rest of this test piece.